NordicTrack Vertex 670 English Manual - Page 11

Cable Assembly 16. Open the parts bags labeled "CABLE ASSEMBLY" and "4 PULLEYS." Refer to the CABLE DIAGRAM on page 21 to identify the cables and for correct cable routing. Locate the Leg Press Cable (76). Attach the Leg Press Cable to the indicated hole in the Leg Press Base (84) with a 3/8" x 3" Bolt (45), two 3/8" Washers (55), a 5/8" x 1/4" Bushing (90), and a 3/8" Nylon Jamnut (63). 17. Wrap the Leg Press Cable (76) up around a 4" Pulley (35). Attach the Pulley and a Cable Trap (44) to the Rear Leg Press Upright (97) with a 3/8" x 3 3/4" Bolt (92), a 3/8" Washer (55), and a 3/8" Nylon Locknut (50). Be sure that the Leg Press Cable (76) is routed in the direction shown, and that the Cable Trap (44) is positioned to hold the Cable in the pulley groove. 16 45 17 84 55 63 76 90 55 97 92 35 44 76 50 55 18. Route the Leg Press Cable (76) under a 4" Pulley (35). Attach the Pulley and a Cable Trap (44) to the Leg Press Base (84) with a 3/8" x 3 3/4" Bolt (92), a 3/8" Washer (55), and a 3/8" Nylon Locknut (50). Be sure that the Cable Trap (44) is positioned to hold the Cable in the pulley groove. 19. Wrap the Leg Press Cable (76) around a 4" Pulley (35). Attach the Pulley and a Cable Trap (44) to the 3/8" x 5" Carriage Bolt (82) in the Stabilizer (5) with a 3/8" Nylon Locknut (50). Be sure that the Leg Press Cable (76) is routed in the direction shown, and that the Cable Trap (44) is positioned to hold the Cable in the pulley groove. 18 76 50 55 44 92 35 84 19 50 35 44 76 82 5 11