NordicTrack Viewpoint 2800 Treadmill Canadian English Manual - Page 12
Hold the receiver so
View all NordicTrack Viewpoint 2800 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
If you purchase the optional chest pulse sensor (see page 31), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove 1 the indicated Screws (99) and the two Console Screws 98 (32) from the Console Base (98). 99 99 99 99 32 99 2. Have a second person carefully lift the pulse plates and the Console Base (98). Be careful not to pull any wires. Connect the wire on the receiver (A) to the indicated wire extending from the Console (105). Hold the receiver so the small cylinder is oriented as shown. Then, remove the tape from the back of the receiver, and press the receiver onto the Console Base (98) in the location shown. 3. While making sure that no wires are pinched, set the Console (105) on the Console Base (98). Place the pulse plates on the Console and the metal crossbar. Reattach the Console and the pulse plates with the Screws (99) and the Console Screws (32) (see step 1). Discard the other wires included with the receiver. 2 Pulse Plate 105 Pulse Plate A Wire Small Cylinder 98 12