Oki 62427202 User Manual - Page 94

B4400/B4600 User's Guide - Troubleshooting > 94

Get Oki 62427202 PDF manuals and user guides View all Oki 62427202 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 94 highlights

SYMPTOM PROBLEM SOLUTION Printer freezes or displays error message when computer is rebooted. Odours. Printer is on but must warm up before a job is printed. Booting the computer while the printer is on can cause a communications error. Gases are given off by forms or adhesives passing through the hot fusing unit. Power Save mode is set on to conserve energy. The fuser must heat up before you can begin printing the next job. Turn printer off before rebooting computer. Make sure the forms you use can withstand heating, and provide adequate ventilation. To eliminate warm up delay, change Power Save setting B4400/B4600 User's Guide - Troubleshooting > 94

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
B4400/B4600 User’s Guide – Troubleshooting > 94
Printer freezes
or displays error
message when
computer is
rebooted.
Booting the
computer while the
printer is on can
cause a
communications
error.
Turn printer off before rebooting
computer.
Odours.
Gases are given off
by forms or
adhesives passing
through the hot
fusing unit.
Make sure the forms you use can
withstand heating, and provide
adequate ventilation.
Printer is on but
must warm up
before a job is
printed.
Power Save mode is
set on to conserve
energy. The fuser
must heat up
before you can
begin printing the
next job.
To eliminate warm up delay, change
Power Save setting
SYMPTOM
PROBLEM
SOLUTION