Oki GL412e GL408e/GL412e User's Guide - Page 62
CONFIGURATION MODE TABLE 4-2, DESCRIPTION, USER MODE TABLE 4-1, Disable, Manual, Automatic, Labels
View all Oki GL412e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
MENU Ribbon Near End Enable* Units In Millimeters* Set Label Length Manual* TOF Detect Fault 3 labels* TOF Adjust Mode Disable* TOF Adjust 10.1 mm* MENU CONFIG MODE Unit 4: Printer Configuration USER MODE (TABLE 4-1) DESCRIPTION When enabled and the amount of ribbon remaining on the supply spindle is approximately 75 to 50 meters or less, the ON LINE indicator of the operator panel will flash and 'Ribbon Low' will display on the second line of the LCD. The warning message will not prevent printing. The Display Ribbon option must be enabled for the warning to display. Disable is the factory default setting. This menu screen allows selection of millimeters or inches as the unit of measure. Inches is the factory default. Allows selection of whether the Sensed Distance value derived from an Auto or Manual Calibrate will be used to set the Label Length value in the Media Setup menu. • Manual - factory default. The Sensed Distance value derived from an Auto or Manual Calibrate will not override or change the Label Length value. • Automatic - when an Auto or Manual Calibrate is performed, the Sensed Distance value derived from either calibration will override and change the Label Length value. If Auto or Calibrate is not performed, the current Label Length value will be used. Note: When Set Label Length = Automatic and the label sensor is set to Gap, the printer will subtract the Gap Length value (in the Sensor Setup menu of the Advanced Mode) from the Sensed Distance value obtained when the Auto or Manual Calibrate was performed. Setting the label length to 'Automatic' sets the 'Use Label Length' menu to 'Disable' in the Sensor Setup menu of the Advanced Mode. Allows selection of top-of-form detection fault. The printer displays a 'Gap Not Detected' fault and stops printing when media has advanced a distance equal to the selected quantity or more times the Label Length value set in menu. • 3 Labels - factory default. • 9 Labels • 1 Label Allows the top-of-form distance to be set using the TOF Adjust menu. • Enable - enables the adjustment through the TOF Adjust menu. • Disable - factory default. Disables the adjustment through the TOF Adjust menu. This option sets the distance from the top-of-form (TOF) that is left blank (unprinted) after a label has been removed in Tear-Off Strip. Printing normally starts at top-of-form, but when enabled, the print start position can be adjusted from 0.00 to 0.40 inches from top-of-form in increments of 0.01 inches. This adjustment is useful if a die-cut label sticks to the platen because of jagged edges created by poor label removal using the tear bar. By controlling how much blank space there is from topof-form, the amount of media called back after being torn off can be controlled. CONFIGURATION MODE (TABLE 4-2) DESCRIPTION Permits entry into the CONFIGURATION Mode. GL408-412e Operator Manual 4-26 PN: 9001163A