Oki OKIPAGE14e Users' Guide for the OkiLAN 6010e - Page 155
Show Network, Printer, Information, are the same as the unit you are configuring.
View all Oki OKIPAGE14e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Section IV - TCP/IP • Verify the OkiLAN 6010e is on the same subnet as the host from which you are telneting. As a drastic measure, try creating an isolated subnet with your host and the OkiLAN 6010e. If you are using 10BASE2, run the cable directly from the host to the OkiLAN 6010e. If using 10BASE-T cabling, connect the host to the OkiLAN 6010e through a hub not connected to any other host. • If the static route has been set up and can telnet to the OkiLAN 6010e, but your changes do not seem to be saved, check the host's routing tables. You might have telneted to a different OkiLAN 6010e than the one you intended. While in telnet, select the second menu option, Show Network/ Printer Information. The hardware address and serial number are displayed. Verify they are the same as the unit you are configuring. • Turn off the OkiLAN 6010e you want to configure. Run telnet again. If you reach a different device, there is an IP address conflict. • If you are able to ping to the OkiLAN 6010e, but are unable to telnet, the IP address is probably being shared with another device that does not support telnet. OKI OkiLAN 6010e User's Guide IV - 65 TCP/IP