Olympus E-20 E-20N Reference Manual (English) - Page 13

Control panel Flash control ➝ 42, 89 The (flash suppression) mark displays when the built-in flash is closed. Nothing displays for Auto flash mode. Slow synchro Flash Fill-in flash intensity control Red-eye reduction Record mode ➝ 108 TIFF*, SHQ, HQ, or SQ * Indicates RAW when blinking • displays When the PS mode is set (➝ 80) or sharpness/contrast setting is not set to NORMAL (➝ 113, 114). • blinks When the noise reduction mode is set (➝ 115) ISO (Displays setting other than AUTO) ➝ 88 White balance (Displays setting other than AUTO) ➝ 104, 105, 107 2nd-curtain Manual focus ➝ 68 Auto bracket ➝ 86 Shutter speed ➝ 74 Aperture value ➝ 72 Macro ➝ 40 Self-timer ➝ 121 Conversion lens ➝ 139 Battery check ➝ 29 Card error ➝ 199 Exposure compensation/ Exposure level In the P, A, S modes displays exposure compensation value. (➝ 84) In the M mode displays the exposure level (the difference between the selected and ideal exposure levels). (➝ 77) Remote control ➝ 122 Metering mode ➝ 83 Sequential shooting ➝ 120 Selected memory card SmartMedia CompactFlash /Microdrive ➝ 129 Digital ESP metering Center weighted averaging metering Spot metering Memory gauge ➝ 38 Indicates shots are stored in Number of storable pictures ➝ 30 At power on, also displays a percentage for the battery check for the lithium polymer battery. temporary memory (a buffer). Goes off after pictures are stored on a card. When the memory gauge is blinking, the buffer is full and you Note cannot take a picture. • If you half-press the shutter button, the viewfinder display will light on. The viewfinder display goes off eight seconds after you release the button. • After the camera is switched on, you will see "- - " displayed for the aperture, shutter Indicates the number of pictures in the buffer. The bars disappear as the When the bars are blinking, you cannot take a picture. The number of blinking bars varies depending on the following settings: speed, and exposure level settings until you half-press the shutter button. When you pictures move from the buffer to the card. • IS/PS/Noise reduction mode setting (➝ 78, 80, 115) • Record mode setting (➝ 108) release the shutter-button from half-pressing, you will see "- -" displayed again after 8 11 seconds.