Olympus E-20 E-20N Reference Manual (English) - Page 197
Built-in flash does not fire., Monitor difficult to see., Cannot transfer data to computer
UPC - 050332147980
View all Olympus E-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
Built-in flash does not fire. Problem Is the built-in flash raised? Is the subject brightly lit? Solution Press the flash button unit. to raise the flash If there is sufficient incident light, the flash will not fire. If you must use the flash, use the fill-in flash mode. Page © 42 © 91 Monitor difficult to see. Problem Monitor dark? Sunlight striking the monitor? Solution Adjust the monitor brightness. Use your hand to block the glare from sunlight so you can see the monitor. Page © 150 − Cannot transfer data to computer. Problem Is the cable connected securely? Solution Check the connection at the camera and computer and make sure the connections are tight. Something other than lines displayed in the See "Cannot operate the camera, monitor control panel? Cannot operate the camera? and control panel blank." Is the USB driver correctly installed? If your operating system is Windows 98/98SE, install the USB driver following the instructions in the "Software Installation Guide." Page © 176 © 192 © 176 195