Onkyo AS-V620 Owner Manual - Page 13

Remote control r .-1 co POWER La"aciii SOURCE CD 10 INPUTSELECTOR.. LEVEL CAPlE4 TOU.NER PHONO= CO 11 1CA;; Vg; DECK-A En En VGi V;P3 DECK-S TUNER C- 1 CD CROUP Prt!'r. C:O C:7.1 A r I O O MUTING ( ) 13 ='1 OLSO 1 .• • A ' A. LEYEEIER 17-Vit VOLUME • V FUNCTION = TEST • En O O 14 SURROUND DELAY ONKYO RI REMOTE CON ROL RC-2137, 0 Sleep button (SLEEP) (Remote control transmitter only) Press to set the power off timer. The sleep timer is a function which turns off the power to the system from the time it is set. When this button is pressed, "90 MIN" is displayed for 5 seconds, and the power goes off 90 minutes later. Each time the button is pressed during 5 seconds, the timer setting changes, by I() minute intervals, such as 80, 70, 60 .... While the sleep timer is operating, the SLEEP indicator is lit. If the sleep button is pressed during this time, the amount of time remaining on the sleep timer is displayed, and if the button is pressed during that display, 10 minutes will be subtracted from that time. If the button is pressed when the panel display shows 10 minutes or less, the sleep timer is cancelled, and the power is not turned off. O2 Power button (POWER) [14, 15] 0 Input selector buttons [14, 22] (TAPE-1, TUNER, PHONO, CD, TAPE-2, VIDEO-I, VIDEO2, VIDEO-3) When the TUNER button is pressed, the station which was received previously is recalled. Selection of AM or FM should be done on the main unit. ® Tape oeration buttons (DECK-A, DECK-B) These buttons control ONKYO double cassette tape decks that can be remote controlled. Use the DECK-B buttons to control single cassette tape decks with the R I mark. : When this is pressed, the recording stand-by mode is entered. : The tape plays, moving from right to left, or, in the recording stand-by mode, recording begins. • : Interrupts all operations. : The tape plays, moving from left to right, or, in the recording stand-by mode, recording begins. : Fast forward from right to left. : Fast forward from left to right. 0 CD operation buttons (CD) These buttons are used to operate an ONKYO CD player with the RI mark. : Press this button to play the CD player. II : Press this button to pause the CD play back. To resume disc play, press the button. DISC : Press to use for sequential selection of discs in the order they were loaded on the CD changer. • : Press this button to stop the CD player. 141 : Press this button to go back to the beginning of the current track and again to skip back to the previous track. : Press this button to skip to the next track. 0 Test tone button (TEST) [18] 0 Surround mode button (SURROUND MODE) [17, 18] ® Delay time button (DELAY TIME) [17, 18] 0 Speaker selector buttons (SPEAKERS MAIN/REMOTE) [14, 15, 22] to Multi source button (MULTI SOURCE) [22] 11 Multi source level up/down buttons [22] (LEVEL A/V) Tuner operation buttons (TUNER) These buttons control ONKYO tuner with the RI mark. GROUP: Group selector button PRESET A/V: Preset memory up/down buttons 0 Audio muting button (MUTING) This button temporarily switches off the sound from the speakers or headphone by operating this unit audio muting circuits. The audio muting indicator "AUDIO MUTING" will flash. Pressing the button again or using the POWER button to turn the power on will turn off the audio muting. • Pressing this button does not mute the sound of the multi source. Press the SPEAKERS REMOTE button to mute the sound of the multi source. ® Volume buttons (VOLUME •/V ) [14, 15] g Center level up/down buttons (CENTER LEVEL A/V) Rear level up/down buttons (REAR LEVEL A /V ) [18] 13