Onkyo AS-V620 Owner Manual - Page 22

VIDE 2 3 REC OUT 4 TAPE -I TAPE-2 TUNER PHONO CD MONITOR Mixinkaaavi,deo aft audio to VCR reco 1. Press the Input Selector button to select the VCR (VIDEO1, 2 or 3) that will be used to play the video. 2. l'ress the REC/PAUSE button on the VCR (VIDEO-2 or 3) that will be doing the recording. 3. Press the REC OUT button. 4. Press the Input Selector button (CD, PHONO, TUNER, TAPE-1 or TAPE-2) that will provide the audio source. 5. Start operation of the equipment. The picture will be left as is. Only the audio will be changed. The picture will be recorded from the video source, and the sound from the audio source. Listening to devices connected to this unit in another room The A-SV620 allows you to listen to the desired performance in another room (sub room) while listening to the playback of a device located in the main room. To do this, connect the speakers in another room to the Front SPEAKERS REMOTE terminals on the A-SV620. Remote control from another room can be done by employing the Multiple Room Remote System (rtr4g). Refer to the connections for Multiple Room Remote Control. Be sure to operate the remote control pointing it at the Remote Sensor. MR off button (MR OFF) and indicator Use this button for tape recording or for the Surround sound modes. It is used to disable control of the ITTRX system via the remote control in another room. Pressing this button will illuminate the indicator, and control from another room will be disabled. Pressing the button again will turn the indicator off, and control from the another room will be enabled. Using the remote control You can use the remote control supplied with this Amplifier to operate the source devices selected for the multi-source if they are an ONKYO CD, tuner or cassette deck bearing the R I mark. If you require a second remote control for the sub room, there is a remote control RC-MR Ill for the sub room, which is sold separately. Installation of the Remote Sensor and the Remote Emitter is required to control non-ONKYO devices from another room (sub room). Operate the remote control included with the device by directing the remote control toward the remote sensor installed in the sub room. If a problem occurs, carry out the same operation on this unit's Front panel controls to verify that the problem is with the remote control. If there is no problem when operating this unit directly, check the batteries in the remote control first before assuming that there is a controller malfunction. NOTES: • If remote control operations arc done in another room, the source on the Input Selector may change, or any recording being done on this unit may he interrupted. Press the MR OFF button to disable control from another room. (The MR OFF indicator will be illuminated.) • Some non-ONKYO remote controls cannot be used. 21