Onkyo AS-V620 Owner Manual - Page 8

Onkyo AS-V620 Manual

Page 8 highlights

Making system connections •:: IPM ON (X (TV, I VDP, • IPM ON OFF 11V) (VD'', z VIDEO VIDEO IN OUT AUDIO OUT Q. TO MONITOR TV (VIDEO IN) VIDEO OUT AUDIO OUT Connecting,a monitor (MONITOR OUT) 1. Connect the TV VIDEO input to this unit MONITOR OUT jack. There is no need to perform an audio connection since sound will be sent directly from this unit to the speaker systems. 2. This unit does not have an RF converter. Therefore, it can be used with only a monitor TV equipped with a video input jack. 3. Interference may be caused between the TV and this unit. If this interference occurs, place this unit and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section). IPM (Intelligent Power Management System) If the TV connected to VIDEO-I is turned on, this unit is automatically turned on and the input selector is set to VIDEO-1. The IPM system then automatically switches the unit off when the TV is switched off (provided that the input selector remains set to VIDEO-1). A. Connection where IPM will operate Set the IPM switch to ON. VIDEO-1 TV is displayed on the multi function display. B. Connection where IPM will not operate Set the IPM switch to OFF. VIDEO-1 VDP is displayed on the multi fanction display. NOTES: • This unit will automatically switch on approximately three to five seconds after the TV comes on. • The I PM function is not operating when the TV screen remains blank, even if the TV is switched on. • III 0 T •:: 8 I:1MONO IN vP MONO IN Subwoofer with a built-in amplifier • MI 0888088888 II®® 00 USA and Canadian models •• 9 o Worldwide and European models II 0 411 Connecting the subwoofer speaker The SUBWOOFER PRE OUT jack can be connected to a subwoofer amplifier or to a subwoofer with a built-in amplifier . When connecting anything to the SUBWOOFER PRE OUT jack, set the SPEAKERS A button on the front panel to ON. AC outlets The SWITCHED outlet is switched on and off by the power buttons on the front panel and remote control., The shape, number and total capacity of the AC outlets may differ according to the model and the area where the unit is purchased. Be careful that other components connected to this unit do not exceed the capacity that is printed on the rear panel above the AC outlets.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25

IPM
III
0
T
•::
I:1
MONO
IN
0888
088888
II®®
multi
fanction
display.
The
SUBWOOFER
PRE
OUT
jack
can
be
connected
to
a
sub
-
woofer
amplifier
or
to
a
subwoofer
with
a
built-in
amplifier
.
When
connecting
anything
to
the
SUBWOOFER
PRE
OUT
jack,
set
the
SPEAKERS
A
button
on
the
front
panel
to
ON.
tons
on
the
front
panel
and
remote
control.,