Onkyo HT-R520 Owner Manual - Page 30
Connecting Onkyo, Components, Connecting the Power Cords of Other, Connecting the Power Cord - problem
View all Onkyo HT-R520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
)53@&OCPPL 1BHF .POEBZ .BSDI 1. Connecting the HT-R520-Continued Connecting Onkyo Components To use , you must make an analog audio connection (RCA) between the HT-R520 and the other component, even if they are connected digitally. With (Remote Interactive) you can control your -compatible Onkyo CD player, DVD player, and so on with the HT-R520's remote controller, and use the following special functions: Auto Power On/Standby When you start playback on a component connected via , if the HT-R520 is in Standby, it will turn on and select that component as the input source automatically. Similarly, when the HT-R520 is set to Standby, all components connected via also enter Standby. This function will not work if the component's power cord is connected to the HT-R520's AC OUTLET. Direct Change When playback is started on a component connected via , the HT-R520 automatically selects that component as the input source. If your DVD player is connected to the HT-R520's multichannel input, you must press the [MULTI CH] button to enjoy all channels (see page 33). This is because the Direct Change function only selects the FRONT DVD IN sockets. Remote Control You can use the HT-R520's remote controller to control other -compatible Onkyo components. IN L REMOTE CONTROL COMPONENT VIDEO ANTENNA VIDEO 1 / 2 / 3IN DVD IN OUT AM FM 75 Y PB DIGITAL IN OPTICAL 3 2 PR COAXIAL 1 REMOTE CONTROL VIDEO 2 IN VIDEO 1 OUT IN DVD MONITOR IN OUT VIDEO S VIDEO IN OUT IN L SUBWOOFER PRE OUT R CD TAPE IN IN OUT IN FRONT SURR CENTER L L R VIDEO 2 VIDEO 1 R DVD SUB WOOFER R CD FRONT L R DVD e.g., CD player e.g., DVD player R L ANALOG AUDIO OUT R L ANALOG AUDIO OUT Notes: • Push plugs in all the way to make good connections. • Use only cables for connections. cables are supplied with Onkyo players (DVD, CD, etc.). • Some components have two sockets, you can connect either one to the HT-R520. The other is for connecting additional -compatible components. • Connect the HT-R520's socket to only Onkyo components. Connecting to other manufacturer's components may cause them to malfunction. 30 • Some components may not support all functions. Refer to the manuals supplied with your components. Connecting the Power Cords of Other Components The HT-R520 has AC outlet on its rear panel for connecting the power cord of another AV component. The other component's power switch can be left in the ON position so that it turns on or off when the HT-R520 is set to On or Standby. FRONT SPEAKERS B Class 2 Wiring FRONT SPEAKERS A L SURROUND SPEAKERS L CENTER SPEAKER AC OUTLET AC 120V 60 Hz SWITCHED 120W 1 A MAX. L R R R AV RECEIVER MODEL NO. HT-R 520 SURROUND BACK SPEAKER AC OUTLET AC 120V 60 Hz SWITCHED 120W 1 A MAX. Caution: • Make sure that the capacity of the component that you connect to the AC OUTLET does not exceed the stated capacity (e.g., 100 W). Note: • Onkyo components with sockets should be connected to regular wall outlets. Connecting the Power Cord Notes: • Before connecting the power cord, connect all of your speakers and AV components. • Turning on the HT-R520 may cause a momentary power surge that might interfere with other electrical equipment on the same circuit. If this is a problem, plug the HT-R520 into a different branch circuit.