Onkyo HT-R520 Owner Manual - Page 31

)53@&OCPPL 1BHF  .POEBZ .BSDI 1. Turning On & First Time Setup ON STANDBY ON STANDBY I T V INPUT V1 V2 V3 1 2 3 + DVD MULTI CH 4 5 6 TV CH - CD 7 +10 --/--TONE TAPE 8 0 TUNER 9 T V VOL CLEAR TUNER/ TAPE _ + AMP REMOTE MODE STANDBY/ON DIGITAL INPUT STANDBY/ON A SPEAKERS B PHONES TONE STANDBY STEREO LISTENING MODE DISPLAY DIGITAL INPUT MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VCR TUNING ENTER PRESET MASTER VOLUME SETUP MEMORY TUNING MODE CLEAR TAPE TUNER C D RETURN S VIDEO VIDEO 3 INPUT VIDEO L AUDIO R Input selector buttons TAPE Turning On the HT-R520 STANDBY/ON Press the [STANDBY/ON] button. Alternatively, press the remote controller's [AMP] button fol- lowed by the [ON] button. The HT-R520 comes on, the display Remote lights up, and the STANDBY indicator controller goes off. ON STANDBY To turn off the HT-R520, press the [STANDBY/ON] button. The HT-R520 will enter Standby mode. Changing the TAPE/MD/CDR Display If you connect an -compatible Onkyo MiniDisc recorder or CD recorder to the TAPE IN/OUT sockets, for to work properly, you must change this setting. This setting can only be changed on the HT-R520. 1 TAPE Press the [TAPE] input selector button so that "TAPE" appears on the display. 2 TAPE Press and hold down the [TAPE] input selector button (about 3 seconds) to set the display. Repeat this step to select TAPE, MD, or CDR. Assigning the Digital Inputs to Input Sources To enjoy Dolby Digital and DTS, you must connect your DVD player to the HT-R520 by using a digital audio connection (coaxial or optical). With this function you can assign digital audio inputs to input sources. You only need to change these assignments if your connections don't match the default assignments listed below. Input source DVD VIDEO 1 VIDEO 2 VIDEO 3 TAPE CD DIGITAL INPUT COAX (COAXIAL) - - - - (Analog) OPT2 (OPTICAL 2) - - - - (Analog) OPT3 (OPTICAL 3) OPT1 (OPTICAL 1) For example, if you connect your DVD player to the OPTICAL 1 DIGITAL IN, you'll need to change the DVD input source from COAX to OPT 1, and change the CD input source to something other than OPT 1. If you want to use the TAPE input source with only the analog TAPE IN sockets, you'll need to change the TAPE assignment from "OPT3" to "----" (Analog). You can change the assignments as follows. 1 DVD VIDEO 2 TAPE VIDEO 1 VCR VIDEO 3 C D Press the input selector button for the source that you want to assign. (Digital inputs cannot be assigned to the TUNER input source.) 2 DIGITAL INPUT Press the [DIGITAL INPUT] button. The current assignment appears. 3 DIGITAL INPUT Press the [DIGITAL INPUT] button repeatedly to select COAX, OPT1, OPT2, OPT3, or - - - -. 31