Onkyo HT-S490 Owner Manual - Page 21

Speaker Setup STANDBY/ON STANDBY POWER ON OFF A SPEAKERS B SP SEL SW MODE DISPLAY STEREO LISTENING MODE /DTS SURROUND DSP MASTER VOLUME SW MODE SP SEL SW MODE DIGITAL INPUT AUDIO SELECTOR DVD VIDEO 1 VIDEO 2 VCR FM MODE MEMORY CLEAR TUNING PRESET FM AM TAPE C D DIMMER BASS TREBLE AV RECEIVER HT-R490 TEST TONE CH SEL STANDBY/ ON SLEEP DIMMER DISPLAY INPUT SELECTOR CD TAPE TUNER D V D VIDEO 1 VIDEO 2 TUNER SUR MODE SW MODE AUDIO SEL PRESE T MODE TV CABLE SATELLITE VCR STANDBY/ ON DVD CD TAPE CH T V VOL CH DISC TV/ VCR T V VOL MUTING TOP MENU MENU ENTER VOLUME RETURN SETUP TEST TONE CH SEL LEVEL REMOTE CONTROLLER RC-446M VOLUME 5/∞ LEVEL 5/∞ You need to set up the speaker configuration for the speaker system connected to the SPEAKERS A terminals (see page 17). Notes: • The speakers cannot be set up for optimum audio reproduction if the SPEAKERS B system is On (see page 7). • It is not necessary to set up again once you have completed the setup unless you change the speaker configuration. Selecting the speaker configuration Press SP SEL button repeatedly to select the number of channels for the SPEAKERS A system. When the button is pressed, the current speaker setup will be displayed for about 5 seconds. If you want to change it, press the same button again within the 5 seconds. When the button is pressed repeatedly, the number of channels changes as follows: Note: When the subwoofer mode is set to MODE 2 and audio is reproduced in the STEREO mode, the subwoofer may not output audio from certain sources (2 channel-Dolby Digital/DTS source etc.). Adjusting each speaker's relative volume balance (Remote controller only) Adjust each speaker's relative volume balance so that the volume of all speaker's test tones sound equal at the listening position. 1. Press the TEST TONE button. Adjust the volume by gently increasing it with the VOLUME 5 button. Each speaker produces the test tone (pink noise) in the following order: Front left and right speakers Front left, right, and center speakers Front left speaker Center speaker Front left and right, plus surround left and right speakers Front left, right, and center, plus surround left and right speakers Setting the subwoofer mode Press SW MODE button repeatedly to select the subwoofer mode. When the button is pressed, the current subwoofer mode will be displayed for about 5 seconds. If you want to change it, press the same button again within the 5 seconds. When the button is pressed repeatedly, the subwoofer mode changes as follows: When small-with limited bass signal handling-front speakers are connected When large-wideband-front speakers are connected When no subwoofer is connected Front right speaker Surround right speaker Surround left speaker Subwoofer 2. To adjust the level of each speaker, press the CH SEL button to select a speaker and press the LEVEL 5/∞ buttons to raise or lower the level. The test tone should sound at the same level when you hear it in your listening position. You can adjust the level in the range between -12 dB to +12 dB. 3. Press the TEST TONE button to complete adjustment. 21