Onkyo HT-S490 Owner Manual - Page 27
Selecting DOLBY PRO LOGIC II surround
View all Onkyo HT-S490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
To enjoy Surround mode STANDBY/ON STANDBY POWER ON OFF A SPEAKERS B DISPLAY SP SEL SW MODE DIGITAL INPUT AUDIO SELECTOR DVD VIDEO 1 VIDEO 2 VCR Ÿ/DTS SURROUND STEREO DSP INPUT SELECTOR STEREO LISTENING MODE /DTS SURROUND DSP MASTER VOLUME FM MODE MEMORY CLEAR TUNING PRESET FM AM TAPE C D DIMMER BASS TREBLE AV RECEIVER HT-R490 TEST TONE CH SEL STANDBY/ ON SLEEP DIMMER DISPLAY INPUT SELECTOR CD TAPE TUNER D V D VIDEO 1 VIDEO 2 TUNER SUR MODE SW MODE AUDIO SEL PRESE T MODE TV CABLE SATELLITE VCR STANDBY/ ON DVD CD TAPE CH TV VOL CH DISC TV/ VCR TV VOL MUTING TOP MENU MENU ENTER VOLUME RETURN SETUP TEST TONE CH SEL LEVEL REMOTE CONTROLLER RC-446M LEVEL 5/∞ Input selector Relationship between input sources and surround modes The surround modes that can be selected are variable depending on the signal formats employed with the input sources. Input source signal format Source software Listening mode STEREO*1 PRO LOGIC II*2 DOLBY D DTS ORCHESTRA*3 UNPLUGGED*3 ALL CH ST*3 MULTI CH Analog Tape, Record, Tuner G G G G G PCM*4 CD, Audio DVD, Video DVD G G Dolby Digital*5 Video DVD, LD, Digital satellite broadcast G G G G G G dts CD, LD, Video DVD G G MULTI CH*6 Video DVD G *1 Only STEREO can be selected when SP SEL is set to 2 ch or when SPEAKERS B is selected. *2 When SP SEL is set to 3 ch, "3 ST" is displayed in place of "PL II". *3 These modes cannot be selected when SP SEL is set to 2 ch or 3 ch. *4 Only STEREO can be selected when the PCM source has been recorded with a sampling rate 96 kHz. *5 Only DOLBY D (PL II if the source is a 2-channel source) or STEREO can be selected when Dolby Digital surround audio is reproduced. *6 The surround mode cannot be selected when MULTI CH is selected. Selecting DOLBY PRO LOGIC II surround 1. Press an input selector button to select the desired sound source. 2. Press the Ÿ/DTS SURROUND button repeatedly to select DOLBY PRO LOGIC II. The selected mode appears in the display. Each time you press the button, the surround mode changes as follows: You can adjust the level of each speaker. 1. Press the CH SEL button on the remote controller to select a speaker. 2. Press the LEVEL 5/∞ buttons on the remote controller to raise or lower the level. • The speaker levels set here are cleared when this unit is set to STANDBY. (The speaker levels return to the levels set using the test tone.) • When the TEST TONE button on the remote controller is pressed after the above adjustment, the set levels will become the levels adjusted using the test tone by overwriting the existing ones. 3. Play the selected sound source. 27