Onkyo HT-S5600 Owner's Manual English - Page 39

3. Digital Audio (Digital Audio Input) 1 2 3 4 5 6 Menu Digital Audio If you connect a component to a digital audio input, you must assign that input to an input selector. For example, if you connect your CD player to the COAXIAL IN 1, you must assign "COAXIAL1" to the "TV/CD" input selector. Here are the default assignments. Input selector BD/DVD VCR/DVR CBL/SAT GAME AUX TV/CD Default assignment COAXIAL1 ----COAXIAL2 --------OPTICAL ■ BD/DVD, VCR/DVR, CBL/SAT, GAME, AUX, TV/CD ` COAXIAL1, COAXIAL2, OPTICAL: Select the input to which the component has been connected Select if the component is connected to an analog audio input. Note • When an HDMI IN is assigned to an input selector in "HDMI Input" (➔ page 38), the same HDMI IN will be set as a priority in this assignment. In this case, if you want to use the coaxial or optical audio input, make the appropriate selection in the "Audio Selector" (➔ page 44). • Supported sampling rates for PCM signals (stereo/mono) from a digital input (optical and coaxial) are 32/44.1/48/88.2/96 kHz/16, 20, 24 bit. 4. Sp Config (Speaker Configuration) 1 2 3 4 5 6 Menu Sp Config Some of the settings in this section are set automatically by Audyssey 2EQ® Room Correction and Speaker Setup (➔ page 26). Here you can check the settings made by Audyssey 2EQ Room Correction and Speaker Setup, or set them manually, which is useful if you change one of the connected speakers after using Audyssey 2EQ Room Correction and Speaker Setup. This section explains how to specify which speakers are connected and their sizes. Cone diameter For speakers with a cone diameter larger than 6-1/2 inches (16 cm), specify Large (full band). For those with a smaller diameter, specify Small (default crossover 100 Hz). The crossover frequency can be changed in the "Crossover (Crossover Frequency)" (➔ page 40). Note • These settings are not available in either of the following cases: - A pair of headphones is connected. - The "Audio TV Out" setting is set to "On" (➔ page 46). - "HDMI CEC (RIHD)" is set to "On" (➔ page 46) and you're listening through your TV speakers. Advanced Operations ■ Powered Zone 2 ` No ` Yes: Zone 2 speakers can be used. (Powered Zone 2 enabled). Note • When the "Powered Zone 2" setting is set to "Yes" and Zone 2 is turned on, the surround back and front high speakers cannot be used. ■ Subwoofer ` Yes ` No ■ Front ` Small ` Large: Select based on the cone diameter. Note • If the "Subwoofer" setting is set to "No", this setting is fixed to "Large". ■ Center*1, Surround*1 ` Small ` Large: Select based on the cone diameter. ` None ■ Front High*2*3*4 ` Small ` Large: Select based on the cone diameter. ` None ■ Surround Back*2*3*5 ` Small ` Large: Select based on the cone diameter. ` None En-39