Onkyo HT-S5600 Owner's Manual English - Page 42
Source Setup, En-42
View all Onkyo HT-S5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
■ PL IIz Height Gain ` Low ` Mid ` High The Height Gain Control in Dolby Pro Logic IIz enables the listener to select how much gain is applied to the front high speakers. There are three settings, "Low", "Mid" and "High", and the front high speakers are accentuated in that order. While "Mid" is the default listening setting, the listener may adjust the Height Gain Control to their personal preference. Note • If the "Front High" setting is set to "None" (➔ page 39), this setting cannot be selected. • If the "Powered Zone 2" setting is set to "Yes" and Zone 2 is turned on, this setting cannot be selected. ■ Dolby EX ` Auto: If the source signal contains a Dolby EX flag, the Dolby EX listening mode is used. ` Manual: You can select any available listening mode. This setting determines how Dolby EX encoded signals are handled. This setting is unavailable if no surround back speakers are connected. This setting is effective with Dolby Digital, Dolby Digital Plus and Dolby TrueHD only. Note • If the "Surround Back" setting is set to "None" (➔ page 39), this setting cannot be selected. • If the "Powered Zone 2" setting is set to "Yes" and Zone 2 is turned on, this setting cannot be selected. DTS ■ Neo:6 Music Center Image ` 0 to 2 to 5 The DTS Neo:6 Music listening mode creates 6-channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel. Changing the value from "0" to "5" will spread the sound of the center channel to left and right (outwards). Theater-Dimensional ■ Listening Angle ` Wide: Select if the listening angle is greater than 30 degrees. ` Narrow: Select if the listening angle is less than 30 degrees. With this setting, you can optimize the TheaterDimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings. Front left speaker Front right speaker Listening angle: 30° Note • For best results, we recommend setting "Narrow" to 20° and "Wide" to 40°. 8. Source Setup 1 2 3 Advanced Operations 4 5 6 Items can be set individually for each input selector. Preparation Press the input selector buttons to select an input source. Menu Audyssey® Source Setup The tone for each speaker is set automatically by Audyssey 2EQ® Room Correction and Speaker Setup. To enable the following settings, you must first perform the Room Correction and Speaker Setup (➔ page 26). • These technologies cannot be used when: - A pair of headphones is connected, or - Direct listening mode is selected, or - The USB input selector is selected. ■ Audyssey ` Off ` Movie: Select this setting for movie material. The Audyssey indicator lights. ` Music: Select this setting for music material. The Audyssey indicator lights. Note • When "Audyssey Quick Start" has been used for measurement, the "Audyssey" cannot be selected. • Audyssey equalizing does not work for DSD sources. En-42