Onkyo HT-S7500 Owner Manual - Page 21
Source Connection, Remote Mode Setup, Network Connection, Terminating the Initial Setup, En-21
View all Onkyo HT-S7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Source Connection This step checks the connection of source components. 1 Use R/X to select one of the following options, and then press ENTER. `Yes, Continue: Performs the checkings. `No, Skip: Skips this step and continues to "Remote Mode Setup". 2 Select the input selector for which you want to check the connection and press ENTER. The picture of the corresponding source should appear on screen with a verification prompt. 3 When prompted, use R/X to select one of the following options and then press ENTER. ` Yes: Confirms that the source is properly displayed. ` No: Displays an error report. Follow the troubleshooting instructions and recheck the source. 4 Use R/X to select one of the following options, and then press ENTER. ` Yes: Returns to step 2. `No, Done Checking: The setup wizard continues to "Remote Mode Setup". Remote Mode Setup With this step, you can enter remote control codes for the components you want to operate. 1 Use R/X to select one of the following options, and then press ENTER. ` Yes: Performs the remote control code input. Refer to step 5 of "Looking up for Remote Control Codes" (➔ page 68). ` No, Skip: Skips this step and continues to "Network Connection". 2 When you're finished, select one of the following options and press ENTER. ` Yes, Done: The setup wizard continues to "Network Connection". ` No, not yet: You can enter other remote control codes. Turning On & Basic Operations Network Connection This step checks your network connection. 1 Use R/X to select one of the following options, and then press ENTER. ` Yes: Performs the checkings. ` No, Skip: Skips this step and terminates the initial setup. Note • If you use both wired and wireless network connections, the wireless will take priority. For further details, see the instruction manual provided with your wireless device. 2 Follow the instructions on screen to perform the network checking. The checking is complete when the message "Successfully connected." appears at the middle of the screen. Press ENTER to terminate the initial setup. 3 If an error message appears, select one of the following options and press ENTER. ` Retry: Performs the checking again. ` No, Do it Later: Skips this step and terminates the initial setup. The setup wizard goes to "Terminating the Initial Setup". Terminating the Initial Setup This step ends the initial setup process. 1 Press ENTER. To restart the initial setup, select "Initial Setup" in the "Hardware Setup" menu (➔ page 62). En-21