Onkyo HTP-240 Owner Manual - Page 5

)51GN 1BHF  8FEOFTEBZ %FDFNCFS Getting to know Your Speaker Package Subwoofer (SKW-240) ■ Front Front, Center & Surround Speakers (SKF-240F, SKC-240C, SKM-240S, SKB-240) 1 ■ Rear 3 2 1 OUTPUT LEVEL MIN MAX LINE INPUT 4 2 3 To AC outlet A STANDBY/ON indicator Red: Subwoofer in standby mode Green: Subwoofer on With the Auto Standby function, the SKW-240 automatically turns on when an input signal is detected in Standby mode. When there's no input signal for about 20 minutes, the SKW-240 automatically enters Standby mode. B OUTPUT LEVEL control This control is used to adjust the volume of the subwoofer. C LINE INPUT This RCA input should be connected to the subwoofer preout on your DR-S2.2 DVD Receiver, amp, or other receiver with supplied RCA cable. Note: The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on your receiver or amp. 1 Speaker terminals These push terminals are for connecting the speaker to your DR-S2.2 DVD Receiver, amp, or other receiver with the supplied speaker cables. The supplied speaker cables are color-coded for easy identification. Simply connect each cable to the samecolored positive speaker terminal. 2 Keyhole slots These keyhole slots can be used to wall-mount the speaker either horizontally or vertically. 3 Speaker mount/bracket inserts These threaded inserts can be used to attach the speaker either horizontally or vertically to a speaker mount or bracket. Note: Use commercially available 1/4-inch machine screws to attach the speaker to a speaker mount or bracket. 4 Base/stand inserts (other than center speaker) These threaded inserts can be used to mount the speaker on the supplied base (screws included) or an optional Onkyo speaker stand (AS-240). 5