Onkyo SR502S Owner Manual - Page 50

5943@&OCPPL 1BHF  5VFTEBZ 'FCSVBSZ 1. Controlling Other Components You can use the TX-SR502/TX-SR502E's remote controller (RC-567M/RC-569M) to control your other AV components, including those made by other manufacturers. To do this you first need to enter the appropriate remote control code for your DVD player, TV, VCR, cable receiver, or satellite receiver. Then you need to select the corresponding remote controller mode (see page 10). By entering the appropriate remote control code, the [CD], [MD], and [CDR] mode buttons can also be used with other manufacturer's components (e.g., DVD, TV, VCR, satellite or cable receiver). ON STANDBY I T V INPUT V1 V2 V3 1 2 3 DVD MULTI CH 4 5 6 + TV CH - CD 7 +10 --/--TONE TAPE 8 0 TUNER 9 T V VOL CLEAR TUNER/ TAPE _ + AMP REMOTE MODE DVD CD MD CDR TV VCR CABLE SAT DIMMER TV INPUT + CH DISC - PREV CH DISPLAY TOP MENU MENU ENTER EXIT RETURN GUIDE SETUP SLEEP VOL MUTING TV I STANDBY Number buttons DVD, CD, MD, CDR, TV, VCR, CABLE, SAT Entering Remote Control Codes Entering the appropriate remote control code for your TV, VCR, and so on will allow you to control it with the TX-SR502/TX-SR502E's remote controller. You'll need to perform this procedure for each component that you want to control. 1 Look up the remote control code for your component. See "Remote Control Codes" on page 51. 2 While holding down the [DVD], [TV], [VCR], [CABLE], [SAT], [CD], [MD], or [CDR] mode button, press the [STANDBY] button. 3 Within 30 seconds, use the number buttons to enter the 4-digit remote control code. 4 Select the remote controller mode, point the remote controller at the component, and check its operation. Remote controller buttons that can be used in DVD mode are shown on page 12. Those that can be used with the TV, VCR, CABLE, and SAT modes are shown on page 55. If the remote controller works as expected, the code has been entered correctly. If not, try again or try another code. Codes for Onkyo DVD Players The remote control code for an Onkyo DVD player depends on whether it's connected via , as follows: 5001: Use this code if you've connected an cable and an analog audio cable (RCA) to your DVD player. This is the default setting, so if you're using , you don't need to change anything. Point the remote controller at the TX-SR502/ TX-SR502E to operate the DVD player. 5002: Use this code if your DVD player doesn't have an socket, or you're not using . Point the remote controller at the DVD player to operate it. Resetting the [DVD], [CD], [MD] or [CDR] Mode Button By default, the [DVD], [CD], [MD] & [CDR] mode buttons are preprogrammed with remote control codes for controlling Onkyo components connected via . If you've entered another code for a button and now want to return to its default, perform the following procedure. 1 While holding down the mode button that you want to reset, press the TV [ ] button. Release both buttons and wait two seconds. 2 Press the mode button again. The mode button is reset. Resetting the Remote Controller This section explains how to reset the remote controller to its default settings. 1 While holding down the [AMP] mode button, press the [STANDBY] button. Release both buttons and wait five seconds. 2 Press the [AMP] mode button again. The remote controller is reset. 50