Onkyo TX-NR585 Owners Manual - English - Page 99
Multi Zone, Miscellaneous
View all Onkyo TX-NR585 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ 6. Multi Zone 1. Zone 2 Change the settings for Zone 2. Setting Item Default Value Maximum Volume Off Power On Volume Last Setting Details Set the maximum value for Zone 2 to prevent the volume from becoming too loud. Select a value from "Off", and "50" to "99". Set the Zone 2 volume level of when the unit is turned on. Select a value from "Last" (Volume level when the unit was turned off), "Min", "1" to "99" and "Max". • You cannot set a higher value than that of "Maximum Volume". 2. Remote Play Zone Change the settings for remote play. Setting Item Remote Play Zone Default Value Auto Setting Details When playing with AirPlay or Spotify Connect, or when using the Music Server function to play remotely from your PC, you can set whether to play in the main room (where this unit is located) or in a separate room (ZONE 2). "Auto": When the main room input is NET, music is played in the main room. When the separate room input is NET and the main room input is other than NET, then the music is played in the separate room. "Main", "Zone 2": Select when limiting the play zone to a particular room. For example, when playing only in the separate room, select "Zone 2". • This function may not work if playback is already proceeding with the same network function. 7. Miscellaneous 1. Tuner Change the frequency step for the tuner. Setting Item AM/FM Frequency Step Default Value 10 kHz/0.2 MHz Setting Details Select a frequency step to suit your residential area. Select "10 kHz/0.2 MHz" or "9 kHz/0.05 MHz". • When this setting is changed, all radio presets are deleted. 2. Remote ID Change the remote controller ID. Setting Item Remote ID Default Value 1 Setting Details If multiple ONKYO products are installed in the same room, select the ID for the remote control used with this unit from "1", "2" and "3" to prevent interference between the unit and other ONKYO products. After changing the ID on the main unit, set the same ID on the remote controller as the main unit with the following procedure. While pressing and holding the MODE button, press the following buttons for approx. 3 seconds. • To change the remote controller ID to "1": (The remote indicator blinks once.) • To change the remote controller ID to "2": (The remote indicator blinks twice.) • To change the remote controller ID to "3": (The remote indicator blinks three times.) 99 Front Panel≫ Rear Panel≫ Remote≫