Onkyo TX-RZ730 Owners Manual - English - Page 68
Connecting a Pre-main Amplifier ZONE 3
![]() |
View all Onkyo TX-RZ730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Connecting a Pre-main Amplifier (ZONE 3) a a You can enjoy 2-ch audio in the separate room (ZONE 3) while performing playback in the main room (where this unit is located). Use an analog cable to connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of the pre-main amplifier or power amplifier in the separate room. The same source can be played back in the main room and ZONE 3 simultaneously. Also, different sources can be played back in both rooms. • The ZONE 3 PRE/LINE OUT terminal can output only when "2. Speaker" - "Configuration" in the Setup menu ( p131) is set to one of the following. -- When "Speaker Channels" is set to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch" -- When "Speaker Channels" is set to "5.1 ch" or "5.1.2 ch", and "Zone Speaker" is set to "Zone 2/Zone 3" -- When "Speaker Channels" is set to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch", and "Bi-Amp" and "Zone Speaker" is set to "No" • To output audio from an externally connected AV component to ZONE 3, use an analog audio cable for connection. Note that ZONE 3 output is not possible with the connection using a HDMI cable, digital coaxial cable, or digital optical cable. LINE IN BD/DVD Premain Amp. a Analog audio cable 68 Front Panel≫ Rear Panel≫ Remote≫
![](/manual_guide/products/onkyo-txrz730-owners-manual-english-2eea54a/68.png)