Onkyo TX-SR700 Owner Manual - Page 18
Connecting a DVD Player with 2-Channel L/R Audio Output
View all Onkyo TX-SR700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Connections (TX-SR700/700E) Connecting a DVD Player with 2-Channel (L/R) Audio Output ANTENNA FM AM 75 R L PHONO IN GND COMPONENT VIDEO INPUT 2 INPUT 1 OUTPUT Y DIGITAL INPUT OPTICAL 2 1 DIGITAL VIDEO 3 OUTPUT COAXIAL IN OPTICAL VIDEO 2 OUT IN VIDEO 1 OUT IN PB REMOTE PR CONTROL DVD IN MONITOR OUT V ZONE 2 12 V TRIGGE OUT SUBWOOFER PRE OUT IN L R CD COAXIAL DIGITAL INPUT OUT IN IN OUT IN TAPE VIDEO 3 VIDEO 2 S IR IN OUT IN FRONT SURR CENTER L VIDEO 1 R DVD SUB WOOFER : Signal flow 4. Connecting a DVD player (DVD) Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD VIDEO IN jack of the TX-SR700/ 700E. Or if the DVD player has an S video output jack, connect it to the DVD S VIDEO IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the TX-SR700/700E. With the initial settings of the TX-SR700/700E, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks. If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at "Input Setup" → "Component Video" (see page 54). Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the TXSR700/700E. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack. If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the TX-SR700/700E to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks. If the device has a digital output, connect it to either the DIGITAL INPUT COAXIAL jack or the DIGITAL INPUT OPTICAL jack of the TX-SR700/700E depending on the type of connector on the DVD player. With the initial settings of the TX-SR700/700E, the DVD input source is set for digital input at the COAXIAL jack (COAX). If the digital connection is made at a different jack, this must be changed at "Input Setup" → "Digital Input" (see page 53). Note: If the DVD player has both 5.1-channel audio outputs and 2-channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the TX-SR700/700E, use the 2-channel audio output jacks on the DVD player. 18 Y PB Component video output PR Video ouput S video output 4. DVD player (DVD) L (white) R (red) Analog audio output Digital audio output (coaxial)