Onkyo TX-SR700 Owner Manual - Page 48

Selecting an Audio Component Using the tone control: To make bass and treble adjustment work for multichannel sources, you must first set the tone control to "On." To turn on the tone control: 1. Press the SURROUND button (or SURR button on the remote controller). TX-SR700/700E/600/600E Remote controller "Tone On" appears on the display and the tone control is turned on. 2. Press the AUDIO ADJUST button and then the and cursor buttons to select Bass (or Treble). TX-SR700/700E/600/600E Remote controller • Be aware that the main volume display on the front panel will differ if the speaker volume of even one speaker is changed from 0 decibels. In other words, if all the speaker levels are set to 0 decibels and you increase the main volume, the display will rise to "98," "99," and then "MAX." If you now change the level of one speaker to +5 decibels and you increase the main volume, the display will rise to "93," "94," and then "MAX." Switching the display While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the DISPLAY button on the TX-SR700/700E/600/600E or the remote controller. TX-SR700/700E/600/600E Remote controller When an input source other than FM or AM is selected: Input + volume Program format* 3. Press the and cursor buttons to set the desired level. TX-SR700/700E/600/600E Remote controller To turn off the tone control: Press the DIRECT button. TX-SR700/700E/600/600E Remote controller Input + Listening mode or Multich * If the input signal does not have a program format, then this will be skipped. When FM or AM is selected as the input source: FM/AM frequency + ch Preset no. FM/AM + Listening mode "Tone Off" appears on the display and the tone control is turned off. Notes: • When you play back multichannel sources, you can select the Pure Audio mode by pressing the PURE AUDIO button. To exit the Pure Audio mode, press the DIRECT or SURROUND button (TX-SR700/700E only). • If you change the speaker levels in step 4 above, these new levels for multichannel sources will have no effect on the settings at "Level Calibration." Temporarily turning off the sound To turn off the sound momentarily, press the MUTING button on the remote controller. The MUTING indicator will flash and the sound from the speakers or headphones will be switched off by the receiver's audio muting circuit. Press the MUTING button again to turn the sound back on. Flashes Remote controller 48