Optoma HD143X HD243X User Manuel - Page 50

ADDITIONAL INFORMATION Warning indicators When the warning indicators (see below) light up or flash, the projector will automatically shutdown: ‡‡ "LAMP" LED indicator is lit red and if "On/Standby" indicator flashes red. ‡‡ "TEMP" LED indicator is lit red and if "On/Standby" indicator flashes red. This indicates the projector has overheated. Under normal conditions, the project can be switched back on. ‡‡ "TEMP" LED indicator flashes red and if "On/Standby" indicator flashes red. Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator light up or flash, please contact your nearest service center for assistance. LED lightning messages Message Standby state (Input power cord) Power on (Warming) Power on & Lamp lighting Power off (Cooling) Quick Resume (100 secs) Error (Lamp fail) Error (Fan failure) Error (Over Temp) Standby State (Burn in mode) Burnin (Warming) Burnin (Cooling) Power On (Burn in Mode) Power LED (Red) Steady light Flashing Flashing Flashing Flashing (0.5 sec off / 0.5 sec on) Power LED (Green or Blue) Temp-LED (Red) Flashing (0.5 sec off / 0.5 sec on) Steady light Flashing (0.5 sec off / 0.5 sec light). Back to red steady light when cooling fan turns off. Flashing (0.25 sec off / 0.25 sec on) Flashing (0.5 sec off / 0.5 sec on) Flashing Flashing Flashing (0.5 sec off / 0.5 sec on) Flashing Steady light Flashing (0.5 sec off / 0.5 sec on) Lamp-LED (Red) Steady light Flashing (0.5 sec off / 0.5 sec on) ‡‡ Power off: Power Off Power Off? Press power key again. 50 English