Optoma WHD200 User Manual - Page 4

DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. EMI (Electro Magnetic Interference) tested. EN 301 489-17 Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro magnetic Compatibility(EMC) standard for radio equipment; Part 17: Specific conditions for 2,4 GHz wideband transmission systems, 5GHz high performance RLAN equipment and 5,8 GHz Broadband Transmitting Systems EN 60065 Audio，video and similar electronic apparatus-Safety requirements EN 55022 Information technology equipment---Radio disturbance characteristics--- Limits and methods of measurement EN 61000-3-2 Electromagnetic compatibility (EMC)--Part 3-2:Limits---Limits for harmonic current emissions (equipment input current up to and including 16 A per phase) EN 61000-3-3 Electromagnetic compatibility (EMC)--Part 3:Limits---Section 3: Limitation of voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current ≦16 A per phase and not subject to conditional connection EN 55024 Information technology equipment---Equipment---Immunity characteristics---Limits and methods of measurement EN 301 489-1 Electromagnetic compatibility and Radio spectrum Matters (ERM); Electro Magnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements TRADEMARK INFORMATION  HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks of HDMI Licensing LLC. Special Notice  Never use this product nearby an aircraft or medical facility. It can cause interference or undesirable effect on the operation result.  Use of this product in the following locations may result in abnormal video and audio output (noise, blocked image... etc,).  Product installed in the walls made of concrete.  Product is situated near the refrigerator or metal fitment.  A cluttered room where the wireless signals may be blocked  This product has been tested and manufactured to comply with each country's safety rules. However, there is no guarantee that interference will not occur in some installation scenario. If the interference happens, increase the distance between the transmitter and receiver.  WHD200 may interfere 5GHz wireless devices, such as routers or other wireless devices. Therefore, if you have an 802.11n router, configure it to the 2.4 GHz band rather than the 5GHz band.  Optimal range between WHD200 transmitter and receiver is between 2 and 20 meters within line of sight. 3