Oreck Heatwise Infrared Owners Guide - Page 8
Suggestions for Best Performance
View all Oreck Heatwise Infrared manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Operation 2. Press the Time button of the Control Panel - the two zeros to the right will flash (:00), indicating 0 minutes have been set and the DELAY START indicator will illuminate. DELAY START SET TEMP INFRARED-ON 3. Press the UP or DOWN button to select desired number of minutes (up to 59 minutes) that you would like the heater to wait to turn itself on. DELAY START 4. Press the ENTER button - the two zero butStEoTnTEtMoPthe left will flash (00:), indicating 0 hours have beeInNFsReAtR.ED-ON 5. Press the UP or DOWN button to the desired number of hours (up to 24 hours) and then press the ENTER button. 6. DELAY START indicator will flash until the unit comes on after waiting the period of time you have set. 7. To cancel the timer, press the power button and the timer will stop. Switching between Fahrenheit & Celsius Press the DOWN & ENTER buttons simultaneously and hold for about 3 seconds. The display will update automatically. Suggestions for Best Performance To assure maximum performance of your Oreck Heatwise™ Infrared Heater, please review the following recommendations: • Do not locate the heater in an area with a high air exchange rate in and out of the room. Heat produced should be contained in the room. • Try placing the heater near a warmer inside wall and direct the output toward a cooler outside wall. The cooler outside wall will tend to draw the generated heat towards it, which will allow for more efficient heating. • Placing the heater next to a cord air return will draw the heat away from the area to be heated. Try closing or covering the