Oregon Scientific WMR968 User Manual - Page 8

GB THGR968 : Weight Dimension Power : Main RGR968 : Weight Dimension Power : Main BTHR968 : Weight Dimension Power STR928 : Weight Dimension Power back up STR938 : Weight Dimension Power back up : 111.5 g : 113.5 (L) x 42.5 (W) x 107.5 (H) : solar cell (STR918) : 276 g : Ø 113.5 x 145 (H) : sole cell (STR918) : 78.4 g : 180 (L) x 70 (W) x 19 (H) : 4 x UM4 - "AAA" size alkaline battery R&TTE Compliance Note This device complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directive, if used for its intended use and that the following standard(s) has been applied: Electromagnetic compatibility (Article 3.1.b of the R&TTE Directive) Applied standards ETS 300 683 : 1997 Efficient use of the radio frequency spectrum (Article 3.2 of the R&TTE Directive) Applied standards EN300 220 -1 : 1997 INTENDED USE OF THE DEVICE : 266 g : 115 (L) x 81 (W) x 138 (H) : 2 x UM3- "AA" size alkaline battery (recommend super lithium battery for weather condition under 32°F) : 290 g : 115 (L) x 81 (W) x 138 (H) : 2 x UM3- "AA" size alkaline battery (recommend super lithium battery for weather condition under 32°F) CAUTION - The content of this manual is subject to change without further notice. - Due to printing limitation, the displays shown in this manual may differ from the actual display. - The contents of this manual may not be reproduced without the permission of the manufacturer. NOTE ON COMPLIANCE Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC : NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: † Reorient or relocate the receiving antenna. † Increase the separation between the equipment and receiver. † Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. † Consult the dealer of an experienced radio/TV technician for help. 928N-USE.p65 8 8 08/10/2001, 12:20 PM