Palsonic pw112sbf Instruction Manual - Page 9

department if the issues are not settled. Whether the freezer is plugged and connected to power; Inoperation Low voltage; Failure power or tripping circuit Odorous foods should closely wrapped; Odour Whether foods are rotten; Whether the interior shall be cleaned. It is normal that refrigerator operates for longer time in Long-term operation of compressor summer when the ambient temperature is higher; Do not put too much food in the freezer at one time; Do not put foods until they are cooled; Frequent opening of refrigerator door. Illuminating light does not Whether the refrigerator is connected to power, shine whether the illuminating light is damaged. The refrigerator door can not be properly closed. The freezer door is stuck by food packages; Too much food; Tilt refrigerator. Whether the food is leveled, whether the refrigerator is Loud noises balanced; Whether the refrigerator parts are properly placed. 7.1 Warm tips: ◆The refrigerator enclosure may emit heat during operation specially in summer, this is caused by the radiation of the condenser, and it is a normal phenomenon. ◆Condensation: condensation phenomenon will be detected on the exterior surface and door seals of the freezer when the ambient humidity is large, this is a normal phenomenon, and the condensation can be wiped away with a dry towel. ◆Buzz: Buzz will be generated by running compressor specially when starting up or shutting down. 8. TIPS FOR ENERGY SAVING Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, close it as soon as possible. Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance). In normal temperature conditions, please arrange the thermostat at the middle setting. Before loading the appliance with packages of fresh food, make sure they are cooled to ambient temperature. Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3-5 mm thick. If it is the outer condenser, the rear wall should be always clean free of dust or any impurities. Always consider instructions stated in the ＂Positioning and Energy Saving Tips＂sections， otherwise the energy consumption might be substantially higher. 7