Panamax M7500-PRO Manual - Page 13

MAX PRO-SERIES Communication/Configuration Specifications (continued) Command String 1.9 !SET_FEEDBACK mode mode = { ON, OFF } 1.10 !SET_LINEFEED mode mode = { ON, OFF } 1.11 !RESET_ALL Action Response Sets the feedback to ON (unsolicited) or OFF (polled). When ON, a message will be sent to the controller every time the status of an input (i.e. trigger), output (i.e. outlet) or power state (i.e. overvoltage) changes. If feedback is OFF, the controller must request feedback. If mode = ON, $FEEDBACK = ON If mode = OFF, $FEEDBACK = OFF If mode is invalid, $INVALID_PARAMETER Controls the linefeeds (ASCII: 10d, 0Ah) sent with each response. When ON, each response will end with a linefeed. When OFF, all responses will not end with a linefeed. If mode = ON, $LINEFEED = ON If mode = OFF, $LINEFEED = OFF If mode is invalid, $INVALID_PARAMETER Resets all of the custom configuration settings (i.e. triggers, delays, meter brightness, feedback mode, & linefeed mode) to their original factory settings listed below. $FACTORY SETTINGS RESTORED Resets the configuration below: TRIGGER FOR 1 = BUTTON TRIGGER FOR 2 = BUTTON TRIGGER FOR 3 = BUTTON TRIGGER FOR 4 = BUTTON TRIGGER FOR HC1 = BUTTON TRIGGER FOR HC2 = BUTTON TRIGGER FOR TRIGOUT = TRIGIN DELAY FOR 1 = 000,005 DELAY FOR 2 = 001,004 DELAY FOR 3 = 002,003 DELAY FOR 4 = 003,002 DELAY FOR HC1 = 004,001 DELAY FOR HC2 = 005,000 DELAY FOR TRIGOUT = 005,000 BRIGHTNESS = 100 FEEDBACK = ON LINEFEED = ON 11