Panasonic AG-AC160A Operating Instructions Basic - Page 27

Using the AC adaptor, Adjusting the hand strap

Get Panasonic AG-AC160A PDF manuals and user guides View all Panasonic AG-AC160A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Preparation Using the AC adaptor Installation 1 Connect the DC cord to the AC adaptor. 2 Plug the AC cord into the power outlet. 3 Insert the DC cord's battery connector until it clicks into place. DC cord's battery connector Removal 1 Turn the POWER/MODE switch (Page 30), and confirm that the mode lamp is off. 2 Remove the DC cord's battery connector while pressing the battery release button. 3 Disconnect the AC cord from the power outlet. ••The battery cannot be recharged when a DC cord is connected to the AC adaptor. (For AG-AC160AP/AG-AC160AEN only) ••Disconnect the AC cord from the power outlet when this device is not in use. Example: AG-AC160AP CAUTION: • This apparatus can be operated at a voltage in the range of 110 - 240 V AC. Voltages other than 120 V are not intended for U.S.A. and Canada. Operation at a voltage other than 120 V AC may require the use of a different AC plug. Please contact either a local or foreign Panasonic authorized service center for assistance in selecting an alternate AC plug. Adjusting the hand strap Adjust the hand strap to suit your hand. 1 Open the cover and adjust the length of the strap. 2 Close the cover. ••Make sure that the cover is firmly closed. 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
27
Preparation
Using the AC adaptor
Installation
1
Connect the DC cord to the AC adaptor.
2
Plug the AC cord into the power outlet.
3
Insert the DC cord’s battery connector until
it clicks into place.
DC cord’s battery connector
Example: AG-AC160AP
Removal
1
Turn the POWER/MODE switch <OFF> (Page 30),
and confirm that the mode lamp is off.
2
Remove the DC cord’s battery connector
while pressing the battery release button.
3
Disconnect the AC cord from the power
outlet.
•
The battery cannot be recharged when a DC
cord is connected to the AC adaptor. (For
AG-AC160AP/AG-AC160AEN only)
•
Disconnect the AC cord from the power outlet
when this device is not in use.
CAUTION:
•
This apparatus can be operated at a volt-
age in the range of 110 – 240 V AC.
Voltages other than 120 V are not intended
for U.S.A. and Canada.
Operation at a voltage other than 120 V AC
may require the use of a different AC plug.
Please contact either a local or foreign
Panasonic authorized service center for as-
sistance in selecting an alternate AC plug.
Adjusting the hand strap
Adjust the hand strap to suit your hand.
1
Open the cover and adjust the length of the
strap.
2
Close the cover.
•
Make sure that the cover is firmly closed.