Panasonic AG HVX200 P2 Camcoder - Page 17
Installing and removing the power supply, Connecting and disconnecting the power cord, Installation
View all Panasonic AG HVX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installing and removing the power supply Installing and removing the battery Installation Insert the battery until it clicks into place. Removal 1 Set the POWER switch to OFF, and check that the mode lamp is off. 2 Remove the battery while pressing the battery release button. • Support the battery with your hand to ensure that it will not fall. Preparation Mode lamp Battery release button Connecting and disconnecting the power cord Installation 1 Connect the DC cord to the AC adapter. 2 Plug the AC power supply cord into the power outlet. 3 Insert the DC cord's battery connector until it clicks into place. Removal 1 Set the POWER switch to OFF, and check that the mode lamp is off. 2 Remove the DC cord's battery connector while pressing the battery release button. 3 Disconnect the AC power supply cord from the power outlet. • You cannot charge the battery when supplying power to the camera-recorder from the AC adapter. DC cord's battery connector CAUTION: • This unit can be operated at a voltage in the range of 100-240V AC. An AC plug adapter may be required for voltages other than 120 V AC. If a conversion plug is required, consult with your dealer as to which one is to be purchased. • Disconnect the AC power supply cord from the power outlet when the unit is not going to be used. 17