Panasonic AG HVX200 P2 Camcoder - Page 25
Basic shooting operations (P2 card), Preparing to shoot using a P2 card, Shooting in auto mode - lcd screen part
View all Panasonic AG HVX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Shooting Basic shooting operations (P2 card) P2 Preparing to shoot using a P2 card Shooting in auto mode 1 Switch the MEDIA switch to "P2". 2 Set the POWER switch to ON. (Page 20) 3 Lift up the viewfinder and open the card slot cover. 4 Insert the P2 card securely in the card slot. • There are two card slots. • Be absolutely sure to close the card slot covers to keep the dust out. • Do not remove the P2 card while the P2 card access lamps are blinking orange. (Page 26) 2 ON 3 4 Lock release 1 1 Turn the POWER switch to ON. (Page 20) • Check that the mode lamp (CAMERA) is lighted red. If not, press the mode button. 2 Switch the AUTO/MANUAL switch to AUTO to select auto mode. • "A" appears on the viewfinder and LCD screens. • The focus, gain, iris and white balance are adjusted automatically. 3 Press the START/STOP button (Red) on the POWER switch to start shooting. • Press again to return to the camera to the shooting standby mode. • Use the handle START/STOP button to make it easier to shoot from low angles. 2 LCD side AUTO MANUAL Handle START/STOP button P2 TAPE Do not operate the MEDIA switch when the power is switched ON. If you attempt to operate the MEDIA switch, the message "TURN POWER OFF" will be displayed. In this case, switch OFF the power, and then switch it ON again. Mode button 1 ON CAMERA MCR VCR PC DUB Mode lamp Lock release REC CHECK button 3 Under the following circumstances, even if you press the STOP button it may take some time until the writing to the P2 card finishes. For this reason, the operation will not be acknowledged if you press the START button too soon. • Stopped after only a short recording time • Stopped immediately after the recording has moved to a second P2 card 25