Panasonic AGDVC20P 3 Ccd Dv Camcorder - Page 29

Edit mode Using the DV Cable for Recording (Digital Dubbing) By connecting other digital video equipment with DV terminal and the camera-recorder by using the DV cable (optional) 1, high-image-quality dubbing can be done in digital format. ≥Set to Tape Playback Mode. (Player/recorder) 1 Connect the camera-recorder and digital video equipment with the DV cable. DV 1 DV 2 Set [ADVANCE] >> [REC STDBY] >> [YES]. (Recorder) ≥You do not have to follow this step when the remote control is used in the digital dubbing. 3 Start playback. (Player) 4 Start recording. (Recorder) Press the [3] button to select [¥/;] icon. ≥Or, without operating step 2 While pressing the [¥REC] button on the remote control, press the [1] button. T ¥REC A.DUB V/REW PLAY FF/W STILL ADV PAUSE STILL ADV W VOL STOP 5 Press the [3] button to select the [¥/;] icon again or press the [;] button on the remote control to stop recording. (Recorder) 6 Stop playback. (Player) You can connect a digital video unit equipped with a DV connector and digitally transfer video and audio signals as well as time code. ≥Before proceeding to connect or disconnect DV (IEEE1394) cable, be absolutely sure to turn off the power of the units. ≥Before proceeding to connect the unit which uses a 6-pin type DV connector, carefully check the shape of the DV (IEEE1394) cable and the connectors on the DV (IEEE1394) cable. Connecting a connector upside down may damage the parts inside the unit 6-pin type 4-pin type and cause malfunctioning. Furthermore, connect the DV (IEEE1394) cable to the unit which uses a 6-pin type DV connector first. ≥When recording signals from an external unit, first check that video signals are supplied. ≥While signals from an external unit are being recorded, do not stop output on the external unit side or disconnect any of cables. This may lead to a failure to recognize the signals when you do recording again. ≥Do not apply force when connecting DV (IEEE1394) cable to DV connector as this may damage the connector. ª To cancel the standby for recording When the camera-recorder is standby for recording, press the [4] button and select the [∫] icon. ≥Do not plug or unplug the DV cable during dubbing, or the dubbing may not be completed properly. ≥If a picture (bilingual video, etc.) containing main sound and sub sound has been dubbed, select the desired sound by [SETUP] >> [AUDIO OUT] on playback. ≥Even if you use a device equipped with DV terminals such as IEEE1394, you may not be able to perform digital dubbing in some cases. For more information, see the instructions for equipment connected. ≥Regardless of the menu settings on the recorder, digital dubbing is carried out in the same mode as the [AUDIO REC] mode of the playback tape. ≥The images on the recorder monitor may be disturbed, but it does not affect the recorded images. ≥If a picture containing a copyright protection signal (copy guard) is recorded by the camera-recorder, the picture is distorted by mosaic-like patterns at playback. ≥When wide images are input, the display such as the menu screen or the operation icon is expanded horizontally. ≥While pictures are input from the DV terminal, the operation icon blinks on instead of appearing from the side of the screen when you press the [ENTER] button. 29