Panasonic BT-LH2170 Operating Instructions - Page 28
continued, Submenu, Setting, Description, I-P MODE, ANAMO, SD ASPECT, ZEBRA INT. MIN., INT. MAX.
![]() |
View all Panasonic BT-LH2170 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Main Menu (continued) Submenu I-P MODE *7 MONO *2 ANAMO *8 SD ASPECT *2 SCAN *2*8 ZEBRA INT. MIN. *9 INT. MAX. *9 EXT. MIN. *9 EXT. MAX. *9 Setting MODE1 MODE2 OFF ON OFF ON 4:3 16:9 NORMAL UNDER -7% to 108% (Factory default setting: 70%) -6% to 109% (Factory default setting: 85%) -7% to 108% (Factory default setting: 5%) -6% to 109% (Factory default setting: 100%) Description Selects IP conversion mode. (see "IP mode" (→This page).) [MODE1] Intra-frame interpolation [MODE2] Intra-field interpolation Switches between color and monochrome (MONO). [OFF] Color [ON] Monochrome • When [ON], the [CHROMA] setting of the [PICTURE] (picture adjusting) menu is fixed at 0. With an Anamo lens and HD-SDI input, the picture is resized to Anamo magnification. (the vertically enlarged signal can be vertically compressed and corrected for display). Sets the aspect ratio for SD signal input. [4:3] 4:3 display [16:9] 16:9 display Sets under-scan and normal display. [NORMAL] Normal display [UNDER] Under-scan Sets the range of the ZEBRA function. Displays the minimum value of the INT. range as a percentage of the video signal. Sets the range of the ZEBRA function. Displays the maximum value of the INT. range as a percentage of the video signal. Sets the range of the ZEBRA function. Displays the minimum value of the EXT. range as a percentage of the video signal. Sets the range of the ZEBRA function. Displays the maximum value of the EXT. range as a percentage of the video signal. *2 This menu is grayed out when the same item is assigned to GPI and [GPI CONTROL] is set to [ENABLE]. *7 To use the SUB WINDOW (→page 38) function, A Change settings after exiting the SUB WINDOW function. B It is recommended to use [MODE2] for handling fast video. *8 [SCAN] changes are not reflected in Anamo size display. *9 The ZEBRA function must be set according to the following conditions. [INT. MIN.] < [INT. MAX.] [EXT. MIN.] < [EXT. MAX.] [EXT. MIN.] ≦ [INT. MIN.] [INT. MAX.] ≦ [EXT. MAX.] IP mode [MODE1] performs IP conversion using intra-frame interpolation. This monitor suppresses the delay to within 1 field. The factory default is [MODE1]. [MODE2] performs IP conversion using intra-field interpolation. Since interpolation is performed inside each field, this mode is suitable for checking interlace status. 28
![](/manual_guide/products/panasonic-btlh2170-operating-instructions-ff65566/28.png)