Panasonic CF-51CCMDBBM Notebook Computer - Page 23

List of Error Codes When turning on the computer, if one of the following error codes or messages is displayed, follow the instructions shown below. If the problem persists, or if the error code or message displayed is not shown here, contact Panasonic Technical Support.( Î page 38) Error Code/Message Solution 0211 Keyboard error z If an external keyboard or mouse is connected, disconnect these devices. 0251 System CMOS checksum bad Default configuration used An error has occurred in the memory that stores the Setup Utility settings. This error occurs when the memory content is changed through some inad- vertent operation by a program or other function. z Run the Setup Utility and load the default values, then change the set- tings to the appropriate values as needed. z If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support. 0271 Check date and time settings The date and time setting are incorrect. z Run the Setup Utility and set the date and time correctly. z If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support. 0280 Previous boot incomplete - Default configuration used Press to Setup Startup has failed repeatedly, so the Setup Utility settings have been returned to their default values, and the computer has been booted. z Run the Setup Utility and load the default values, then change the set- tings to the appropriate values as needed. z Write down the error details and press F2 to run the Setup Utility. Confirm the settings, and change the settings to the appropriate values as needed. Operating System not found The OS is not properly installed on the floppy disk or the hard disk that you are trying to boot from. z If the computer cannot be booted from the floppy disk, check the floppy disk drive to ensure that the disk is in fact bootable, and change it to another if not. z If the computer cannot be booted from the hard disk, confirm whether the hard disk is properly recognized in [Information] menu of the Setup Utility. If the hard disk is recognized, perform the reinstallation procedure. If not, contact Panasonic Technical Support. z If a device is connected to the USB port, disconnect the device, or run the Setup Utility and set [Legacy USB Support] to [Disable] in [Security] menu of the Setup Utility. RAM Module Failed z If the RAM module has not been inserted properly, or if a RAM module other than one matching the specifications has been inserted, a beep will sound and the message "RAM Module Failed" will be displayed when turning the power on. In this case, turn the power off, confirm that the RAM module meets the specifications, and reinsert it. „ How to run the Setup Utility 1 Restart the computer. 2 Press F2 while [Panasonic] boot screen is displayed soon after the computer begins the startup procedure. Troubleshooting 23