Panasonic CQC3305U CQC3305U User Guide - Page 7

General  Up  Down Setting Range: 0 to 40 Default: 18 Note: The volume level can be set independently for each source. (For radio, one volume setting for AM, one volume setting for all FMs) Volume Adjustment (VOLUME) Temporary Volume Off (Down) MUTE (ATT: Attenuation) Volume off (down) Press [MUTE]. Cancel Press [MUTE] again. Note: You can select mute or attenuation. ( page 23) Caution • Set the volume level to low enough before the AUX connection is completed. Failure to observe this, the loud noise may come out and damage your speakers and your hearing. The source changes as follows every time [SOURCE] is pressed. AUX1 (AUX1 in) (3.5 mm  stereo) From line output of external sound/audio device (ex. Silicon-audio player, HDD player, etc.) Radio FM1, FM2, FM3, AM ( page 14) System-up Connector When an optional device is connected: Shift to connected device When connecting CD changer Player When loading CD ( page 16) When connecting iPod When connecting XM Receiver When loading MP3/WMA disc ( page 18) When connecting Sirius Receiver Source Selection (SOURCE) AUX1 Device connected to the AUX1 terminal of this unit OR When an expansion module is connected: The devices connected to the ports 1 to 4 are activated in sequence after shifting to AUX2 (device connected to the AUX terminal of the expansion module). Note: For information about connectable devices, refer to the System Upgrade Guidebook or the instruction manual for each device. 12 CQ-C3405U/C3305U SQ Selection Based on Genre SQ (Sound Quality) Sound Control The equalizer curve is selectable from among 4 types (FLAT, ROCK, POP and VOCAL) depending on your listening category. SQ changeover The SQ category is changed every time [SQ] (Sound Quality) is pressed. (FLAT) flat frequency response: does not emphasize any part. (Default) (ROCK) speedy and heavy sound: exaggerates bass and treble. (POP) wide-ranged and deep sound: slightly emphasizes bass and treble. (VOCAL) clear sound: emphasizes middle tone and slightly emphasizes treble. Press [DISP] to return to the regular mode. Notes: • Setting of SQ, bass/treble and volume are influenced one another. If such an influence mentioned above causes distortion to the audio signal, readjust bass/ treble or volume. ( page 22) • Please refer to page 22 for the adjustment to each speaker and an optional subwoofer. · Bass adjustment · Treble adjustment · Balance adjustment · Fader adjustment · Subwoofer level adjustment CQ-C3405U/C3305U 13 General, Sound Control English