Panasonic CQDP133U Auto Radio/cd Deck - Page 15
Electrical Connections, Specifications
UPC - 037988756056
View all Panasonic CQDP133U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
E N Electrical Connections G L I S H Cautions: 19 • This product is designed to operate with a 12 V DC, negative ground battery system. • To prevent damage to the unit, be sure to follow the connection diagram below. • Strip about 5 mm of the lead ends for connection. • Do not insert the power connector into the unit until the wiring is completed. • Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts. • Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected. Supplied hardware No. Item Q'ty y Power connector 1 ❐ Wiring Diagram Only for CQ-DP133U/DPX153U Preamp output connector (front) Only for CQ-DPX153U Sub-Woofer Cord (Monaural) Preamp output connector (rear) S.W.OUT (Red) CQ-DP133U/DP103U/DPX153U Fuse (15 A) C (White) L (White) R (Red) Antenna y Power connector Ground lead To a clean, bare metallic part of car chassis. Motor antenna relay control lead (To motor antenna) (Max. 500 mA) This lead is not intended for use with switch actuated power antenna. (Black) (Dark blue) Note: The power antenna extends automatically when the FM/AM radio mode is selected. FRONT SP C If the fuse (rear panel) blows frequently, they may be something wrong with the unit or wiring. Consult your nearest Panasonic Servicenter for service. BATTERY 15A (Yellow) Battery lead To the car battery, continuous +12 V DC ACC (Red) (Dark blue/ white stripe) Speaker lead REAR SP Power lead To ACC power, +12 V DC Amp. relay control power lead (Max. 500 mA) This lead is for connection to the power amplifier. Note: This lead is used for power control when an external power amplifier is connected. The power supply of a power amplifier will be activated when turning on the power of this unit. (White/ (White) (Gray/black (Gray) black stripe) stripe) (-) (+) (-) (+) (Green/black (Green) (Violet/black (Violet) stripe) stripe) (-) (+) (-) (+) Left speaker (Front) Right speaker (Front) 28 CQ-DP133U/DP103U/DPX153U Left speaker (Rear) Right speaker (Rear) Specifications E N G L I ❐ General S H Power supply: 12 V DC (11 V-16 V), test voltage 14.4 V, negative ground 20 Current consumption: Less than 2.2 A (CD play mode; 0.5 W×4 channels) Maximum power output: 45 W×4 channels at 1 kHz, volume control maximum Tone adjustment range: Bass: ±12 dB at 100 Hz Treble: ±12 dB at 10 kHz Suitable speaker impedance: 4-8 Ω Preamp output voltage: 2.5 V (CD play mode; 1 kHz, 0 dB) Output impedance: 200 Ω Dimensions (W×H×D): 7"×115/16 "×57/8 " (178×50×155 mm) Weight: 3 lbs. 1 oz (1.4 kg) ❐ FM Stereo Radio Frequency range: Usable sensitivity: 50 dB quieting sensitivity: Frequency response: Alternate channel selectivity: Stereo separation: Image response ratio: IF response ratio: Signal/noise ratio: 87.9 MHz-107.9 MHz 11.0 dBf. (1.25 µV, 75 Ω) 15.2 dBf. (1.6 µV, 75 Ω) 30 Hz-15 kHz (±3 dB) 75 dB 42 dB (1 kHz) 75 dB 100 dB 70 dB ❐ AM Radio Frequency range: Usable sensitivity: 530 kHz-1 710 kHz 28 dB/µV (25 µV, S/N 20 dB) ❐ CD Player Sampling frequency: DA converter: Error correction system: Pick-up type: Light source: Wave length: Frequency response: Signal/noise ratio: Total harmonic distortion: Wow and flutter: Channel separation: 8 times oversampling 1 bit DAC system Panasonic super decoding algorithm Astigma 3-beam Semiconductor laser 780 nm 20 Hz-20 kHz (±1 dB) 96 dB 0.01 % (1 kHz) Below measurable limits 75 dB Above specifications comply with EIA standards. Note: Specifications and the design are subject to modification without notice due to improvements in technology. 29 CQ-DP133U/DP103U/DPX153U