Panasonic CQDP133U Auto Radio/cd Deck - Page 6

Power And Sound Controls, Clock Setting - cq dp133u

Page 6 highlights

BAND BAND E N Power and Sound Controls G L I S H Power Display Change 1 Turn the key in the ignition until the accessory indicator lights. Press [DISP] (display) to switch to the clock display. Power on: Press [SRC] (POWER). When the power is off: Power off: Press [SRC] (POWER) again and hold. No display Clock display ACC ON Note: Please refer to next page when "AdJ" is displayed. Remote control sensor (only for CQ-DP133U/DPX153U) VOLUME PUSH SEL APM POWER SRC 7 MUTE 1 8 9 2 3 CQ-DP133U 10 11 45 12 SCAN 6 LOUD D•M TUNE TRACK REP CLOCK DISP Volume Turn the knob clockwise to increase volume, and counterclockwise to decrease volume. Volume level (0 to 40) Up Down Anti-volume-blast circuit: When the power is switched off and on again, the volume slowly rises to the previous level. The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the display. Loudness Press [LOUD] to enhance bass and treble tones at low or medium volume. LOUD lights Press [LOUD] again to cancel. Mute Press [MUTE] to mute the sound completely. MUTE lights Press [MUTE] again to cancel. 10 CQ-DP133U/DP103U/DPX153U Clock Setting Note: If no operation takes place for more than 5 sec- onds in audio mode (2 seconds in volume mode), the E N display returns to the regular mode. G L I Audio Mode The 12-hour system is used for the clock. S H (Bass/Treble/Balance/Fader/Sub Woofer) Initial Time 2 q Push [SEL] to select the audio mode. q Press [DISP] (clock). Volume Bass Treble Sub Woofer Fader (Only for CQ-DPX153U) Balance Push "AdJ" is displayed when the clock is not adjusted. [k TUNE], [l TUNE] (Hours, minutes) VOLUME PUSH SEL APM POWER SRC 7 MUTE 1 8 9 2 3 CQ-DP133U 10 11 45 12 SCAN 6 LOUD D•M TUNE TRACK REP CLOCK DISP w Turn the knob clockwise or conterclockwise to change each level. Bass: Adjustable range: -12 to +12 (by 3dB step) Treble: [DISP] (clock) Hours w Press and hold [DISP] (display) for more than 2 seconds. (Hours blink.) e Press [k TUNE] or [l TUNE]. Adjustable range: -12 to +12 (by 3dB step) Balance: R (right speaker) or L (left speaker) Adjustable range: 1 to 15 (by 1 step) Balance center Fader: F (front speaker) or R (rear speaker) Adjustable range: 1 to 15 (by 1 step) Fader center Sub Woofer: (Only for CQ-DPX153U) Adjustable range (level): MUTE (0) to 8 (Hours set.) Minutes r Press [DISP] (display). (Minutes blink.) t Press [k TUNE] or [l TUNE]. (Minutes set.) y Press [DISP] (display). (End.) Note: Press and hold [k TUNE] or [l TUNE] to change numbers rapidly. Time Reset Press and hold [DISP] (display) for more than 2 seconds to activate the time setting mode to reset the time. Then, repeat steps e to y. 11 CQ-DP133U/DP103U/DPX153U

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37

CQ-DP133U/DP103U/DPX153U
E
N
G
L
I
S
H
2
11
E
N
G
L
I
S
H
1
10
CQ-DP133U/DP103U/DPX153U
POWER
REP
D•M
CLOCK
CQ-DP133U
DISP
TRACK
TUNE
LOUD
MUTE
7
8
9
10
11
12
SCAN
1
2
3
4
6
APM
BAND
SRC
5
V
O
L
U
M
E
P
U
S
H
S
E
L
DISP
LOUD
MUTE
SRC
Anti-volume-blast circuit:
When the power is switched off and on
again, the volume slowly rises to the previ-
ous level.
The anti-volume-blast circuit will not work
when the volume level is set lower than
position 20 on the display.
Power and Sound Controls
Mute
Press
[MUTE]
to mute the sound completely.
lights
Press
[MUTE]
again to cancel.
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Volume level (0 to 40)
Loudness
Press
[LOUD]
to enhance bass and treble tones at
low or medium volume.
lights
Press
[LOUD]
again to cancel.
Power
Turn the key in the ignition until
the accessory indicator lights.
Power on:
Press
[SRC] (POWER).
Power off:
Press
[SRC] (POWER)
again and hold
.
ACC
ON
MUTE
LOUD
Display Change
Press
[DISP]
(display) to switch to the clock display.
Note:
Please refer to next page when "AdJ" is displayed.
When the power is off:
No display
Clock display
Remote control sensor
(only for CQ-DP133U/DPX153U)
Up
Down
POWER
REP
D•M
CLOCK
CQ-DP133U
DISP
TRACK
TUNE
LOUD
MUTE
7
8
9
10
11
12
SCAN
1
2
3
4
6
APM
BAND
SRC
5
V
O
L
U
M
E
P
U
S
H
S
E
L
DISP
TUNE
TRACK
Hours
w
Press and hold
[DISP]
(display) for more than
2 seconds.
e
Press
[
k
TUNE]
or
[
l
TUNE]
.
Minutes
r
Press
[DISP]
(display).
t
Press
[
k
TUNE]
or
[
l
TUNE]
.
y
Press
[DISP]
(display).
Note:
Press and hold
[
k
TUNE]
or
[
l
TUNE]
to
change numbers rapidly.
Audio Mode
(Bass/Treble/Balance/Fader/Sub Woofer)
Volume
Bass
Treble
Balance
Sub Woofer
Fader
Note:
If no operation takes place for more than 5 sec-
onds in audio mode (2 seconds in volume mode), the
display returns to the regular mode.
Bass:
Adjustable range:
12 to +12 (by 3dB step)
Treble:
Adjustable range:
12 to +12 (by 3dB step)
Balance:
R (right speaker) or L (left speaker)
Fader:
F (front speaker) or R (rear speaker)
Push
[SEL]
to select the audio mode.
q
Clock Setting
The 12-hour system is used for the clock.
(Hours blink.)
(Hours set.)
(Minutes blink.)
(Minutes set.)
(End.)
Initial Time
q
Press
[DISP]
(clock).
"AdJ" is displayed when the clock is not
adjusted.
Time Reset
Press and hold
[DISP]
(display) for more than
2 seconds to activate the time setting mode to
reset the time. Then, repeat steps
e
to
y
.
[DISP]
(clock)
[
k
TUNE]
,
[
l
TUNE]
(Hours, minutes)
Adjustable range: 1 to 15 (by 1 step)
Balance center
Adjustable range: 1 to 15 (by 1 step)
Fader center
(Only for CQ-DPX153U)
Sub Woofer:
Adjustable range (level): MUTE (0) to 8
(Only for CQ-DPX153U)
Push
Turn the knob clockwise or conterclockwise to
change each level.
w