Panasonic DMRE30 DMRE30 User Guide - Page 11

3 STEP Plug-in Auto Tuning 1 DVD/TV DVD POWER TV DVD TV ÍÍ VCR Plus+ TV/VIDEO REC MODE REC 12 45 78 CANCEL 0 SKIP 3 CH 6 VOLUME 9 100 SLOW/SEARCH 2≥3 DIRECT NAVIGATOR PLAY LIST TOP MENU ENTER MENU FUNCTIONS RETURN PROG/CHECK ADD/DLT DISPLAY TIME SLIP 1 2 3 X,W, CH ≥ After plugging the unit into your household AC outlet and pressing [Í, DVD POWER] to turn the unit on for the first time, the unit automatically tunes in all the channels it can receive and sets the clock. The unit automatically determines the type of transmission (air or cable) and puts them into channels as follows. ≥TV Mode Band VHF UHF ≥CATV Mode Band VHF CATV LOW BAND CATV MID/SUPER BAND CATV HYPER BAND ULTRA BAND SPECIAL CATV CHANNEL Air 2s13 14s69 Cable 2s13 95s99 14s36 37s65 66s94 100s125 1 Preparation ≥Confirm that the antenna is connected correctly. ≥Turn on the television and select the appropriate video input to suit the connections to this unit. 1 Press [Í, DVD POWER] to turn the unit on. Auto Channel/Clock Setting Connect antenna cable and if you use a cable box, tune it to your local PBS CH then. . . Please push the ENTER key. ENTER RETURN 2 Press [ENTER]. Plug-in Auto Tuning starts and the unit puts the stations it can receive into channels. The unit then proceeds with Auto Clock Setting. The time is displayed when finished. If the clock is an hour slower or faster than the actual time, go to "Time Zone Adjust" to correct it (➜page 54). 3 When the display shows the correct time Press [ENTER] to complete Plug-in Auto Tuning. If the unit couldn't find any channels Press [ENTER] to start Plug-in Auto Tuning again. If the channels still aren't tuned, set "Antenna System" manually and proceed to "Auto Channel Setting" (➜page 12, "If Plug-in Auto Tuning fails"). If unnecessary channels are set or necessary channels are not set Refer to page 12, "Adding and deleting channels". If the unit couldn't set the clock automatically Press [ENTER] to show the "Manual Clock Setting" screen. Set the time manually (➜page 54). To start Plug-in Auto Tuning again (after relocation, for example) Antenna system, channel caption, and VCR Plusr guide channel settings all revert to the default values when you perform the procedure below. Timer recording settings are also cleared. When the unit is on and stopped 1 Press and hold [X, CH] and [W, CH] on the main unit for about five seconds. The unit turns off. 2 Press [Í, DVD POWER] to turn the unit on. Press [ENTER] to start Plug-in Auto Tuning. 11 RQT6559 Getting started