Panasonic DMRE30 DMRE30 User Guide - Page 12

Getting started STEP 3 Plug-in Auto Tuning 1 DVD/TV DVD POWER TV DVD TV ÍÍ VCR Plus+ TV/VIDEO REC MODE REC 12 45 78 CANCEL 0 SKIP 3 CH 6 VOLUME 9 100 SLOW/SEARCH DIRECT NAVIGATOR PLAY LIST TOP MENU ENTER MENU 2 1 FUNCTIONS RETURN PROG/CHECK ADD/DLT DISPLAY TIME SLIP OPEN/CLOSE STATUS FRAME SETUP AUDIO INPUT SELECT CM SKIP ERASE F Rec POSITION MEMORY MARKER 1 2≥3≥4≥ 5≥6 RETURN If Plug-in Auto Tuning fails 1 Press [SETUP] to show the menus. SET UP Antenna System CATV Auto Channel Setting Channel Set Up Disc Video Audio Display TV Screen Channel Caption Preset Channel Caption Manual Channel Caption VCR Plusi CH Setting TAB SELECT RETURN 2 Press [3, 4] to select "Channel" and press [1]. SET UP Channel Set Up Disc Video Audio Display TV Screen Antenna System Auto Channel Setting Channel Caption Preset Channel Caption Manual Channel Caption VCR Plusi CH Setting CATV SELECT ENTER TAB RETURN 3 Press [3, 4] to select "Antenna Sys- tem" and press [ENTER]. SET UP Antenna System 12 RQT6559 Channel Set Up Disc Video SELECT TV CATV 4 Press [3, 4] to select "TV" or "CATV" and press [ENTER]. TV: TV broadcast (2CH-69CH) CATV: CATV broadcast (1CH-125CH) The screen shown in step 2 reappears. 5 Press [3, 4] to select "Auto Channel Setting" and press [ENTER]. SET UP Auto Channel Setting Channel Set Up Connect antenna cable and if you use a cable box, tune it to your local PBS CH then... Disc Video Please push the ENTER ke.y Audio Display If you have not yet set clock, the "Auto Channel/Clock Set- ting" screen appears. 6 Press [ENTER]. Auto setting starts. This takes a few minutes. (To stop auto channel setting, press [RETURN].) When finished, the Complete screen or time display is shown. Press [ENTER]. To return to the previous screen Press [RETURN]. When you are finished Press [SETUP]. Adding and deleting channels While this unit is receiving the antenna signal (but not during recording): 1 Press the numbered buttons to select a channel. Example: "5": [0] ➜ [5] "15": [1] ➜ [5] "115": [100] ➜ [1] ➜ [5] Unit's display ≥You can also use [W, X, CH] when you are going to delete a channel. 2 Press [ADD/DLT]. The channel is deleted if it was set or added if it was not set. For example CHANNEL 12 DELETED Repeat steps 1 and 2 as necessary.