Panasonic DMRE30 DMRE30 User Guide - Page 50

Changing the remote control code !? 5 DVD/TV DVD POWER TV DVD TV ÍÍ VCR Plus+ TV/VIDEO REC MODE REC 12 45 78 CANCEL 0 SKIP 3 CH 6 VOLUME 9 100 SLOW/SEARCH 1≥6 DIRECT NAVIGATOR PLAY LIST TOP MENU ENTER MENU FUNCTIONS RETURN PROG/CHECK ADD/DLT DISPLAY TIME SLIP OPEN/CLOSE STATUS FRAME SETUP AUDIO INPUT SELECT CM SKIP ERASE F Rec POSITION MEMORY MARKER 2≥3≥4≥5 2≥3≥4≥5 FUNCTIONS RETURN Most of the DVD recorders and players manufactured by Panasonic use the same remote control system. If you have more than one piece of equipment placed in proximity to each other, they may all respond to the signal. If this occurs, you will have to alter the code on the unit as well as on the remote control (the two must match) using the following procedure. ≥Use "1", the factory set code, under normal circumstances. 1 Press [SETUP] to show the menus. SET UP Antenna System CATV Channel Set Up Disc Video Audio Display TV Screen Auto Channel Setting Channel Caption Preset Channel Caption Manual Channel Caption VCR Plusi CH Setting TAB SELECT RETURN 2 Press [3, 4] to select "Set Up" and press [1]. 3 Press [3, 4] to select "Remote Con- trol Code" and press [ENTER]. 4 Press [3, 4] to select the code (1, 2, or 3) and press [ENTER]. The remote control code on the unit has been set. 5 While pressing [ENTER] on the remote control, press the numbered button ([1], [2] or [3]) corresponding to the code you selected in step 4. The remote control code on the remote control has been set. 6 Press [SETUP] If the unit doesn't respond, you have entered the wrong code. Repeat step 5 to enter the correct code. [Note] ≥The following display appears on the unit's display if its code and the remote control's code are different. Change the remote control's code to suit the unit. The display disappears after about 5 seconds. The unit's remote control code ≥You can also set the main unit's code without using the remote control. 1 Press [FUNCTIONS] on the main unit. 2 Press [3, 4, 2, 1] to select "SETUP" and press [ENTER]. 3 Carry out procedure 2-4 above. 4 Press [RETURN]. Advanced operation 50 RQT6559