Panasonic EH-XC10 EH-XC10 Operating Manual - Page 13

water approximately 4 mL

Get Panasonic EH-XC10 PDF manuals and user guides View all Panasonic EH-XC10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

English Brush cleansing Remove dead skin and dirt from pores with the gentle fine brush and microfoam. If you are still wearing makeup, first remove the makeup using the warm makeup removal mode or remove eye makeup with your hands. 1 Attach the soft brush by pressing it until it clicks into place. 2 Open the facial cleanser compartment and add facial cleanser. Add the recommended amount as indicated on your facial cleanser product (the amount you normally use). Notes • Use a foaming facial cleanser. • Depending on the type of facial cleanser (sticky facial cleansers, etc.) or the amount used, the facial cleanser may not mix properly and clog the appliance. In rare cases, power to the appliance may be interrupted. (See page 16.) • The quality of foam varies depending on the type of facial cleanser. Adjust to the recommended amount as indicated on your facial cleanser product. • Do not add anything other than facial cleanser into this appliance. (Doing so may cause malfunction.) • If you are using a non-foaming type facial cleanser, moisten the brush and your face with water and apply the facial cleanser directly onto your skin. 3 Fill the measuring cap with water (approximately 4 mL) 4 mL and pour into the center of the brush. 4 Press the facial cleanse switch and select a mode. Foam starts to dispense approximately 5 seconds after turning on the appliance. • Pressing the facial cleanse switch cycles through the "Power OFF" "Normal ( )" "Soft ( )" options. • The mode is always set to "Normal ( )" when the power is turned on. • Wash off any excess facial cleanser on your hands. • Add more water if the amount of foam is insufficient. 5 Wash your face. • Do not apply the appliance to the same area for extended periods of time. • Wash your face in 3 sections as illustrated in the following diagram for approximately 20 seconds per section. • You can use this appliance on your neck and upper chest, but do not apply it to your throat. • Recommended ambient temperature for operation is 5 - 35 °C (41 - 95 °F). The appliance might not be usable outside of the recommended temperature range. Notification timer feature Notifies you of the recommended cleansing time by pulsing every 20 seconds. 13 EH-XC10_AM.indb 13 2015/07/21 18:02:24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
13
English
Brush cleansing
Remove dead skin and dirt from pores with the gentle fine brush and
microfoam.
If you are still wearing makeup, first remove the makeup using the
warm makeup removal mode or remove eye makeup with your hands.
1
1
Attach the soft brush by pressing
it until it clicks into place.
2
2
Open the facial cleanser compartment
and add facial cleanser.
Add the recommended amount as
indicated on your facial cleanser product
(the amount you normally use).
Notes
•
Use a foaming facial cleanser.
•
Depending on the type of facial cleanser
(sticky facial cleansers, etc.) or the
amount used, the facial cleanser may not
mix properly and clog the appliance. In
rare cases, power to the appliance may
be interrupted. (See page 16.)
•
The quality of foam varies depending on the type of facial
cleanser. Adjust to the recommended amount as indicated
on your facial cleanser product.
•
Do not add anything other than facial cleanser into this
appliance. (Doing so may cause malfunction.)
•
If you are using a non-foaming type facial cleanser,
moisten the brush and your face with water and apply the
facial cleanser directly onto your skin.
3
3
Fill the measuring cap with
water (approximately 4 mL)
and pour into the center of
the brush.
4 mL
4
4
Press the facial cleanse switch and select a
mode.
Foam starts to dispense approximately 5 seconds after
turning on the appliance.
•
Pressing the facial cleanse switch cycles through the
“Power OFF”
“Normal (
)”
“Soft (
)” options.
•
The mode is always set to “Normal (
)” when the power
is turned on.
•
Wash off any excess facial cleanser on your hands.
•
Add more water if the amount of foam is insufficient.
5
5
Wash your face.
•
Do not apply the appliance to the same area for extended
periods of time.
•
Wash your face in 3 sections as illustrated in the following
diagram for approximately 20 seconds per section.
•
You can use this appliance on your neck and upper chest,
but do not apply it to your throat.
•
Recommended ambient temperature for operation is
5 – 35 °C (41 - 95 °F). The appliance might not be usable
outside of the recommended temperature range.
Notification timer feature
Notifies you of the recommended cleansing time by
pulsing every 20 seconds.
EH-XC10_AM.indb
13
2015/07/21
18:02:24