Panasonic EH-XC10 EH-XC10 Operating Manual - Page 15

English Cleaning 1 Rinse foam off the brush with water and then remove. 2 Open the facial cleanser compartment cover, begin pouring water into the foam dispenser, and then press the facial cleanse switch to rinse. • If a significant amount of facial cleanser remains, the power may turn off a few seconds after pressing the facial cleanse switch or may not operate smoothly. In such cases, use warm water to clean and remove the excess cleanser. 3 Press the facial cleanse switch to turn off the power. 4 Manually clean the brushes, warming makeup removal plate, and around the facial cleanser compartment. 5 Shake the main body to remove excess water. 6 Lightly wipe with a towel or similar and place on the stand to dry. • Leave the facial cleanser compartment cover open to dry. • Place the brush and measuring cap at the rear of the stand. • After cleaning, store in a location with low humidity. (Storing the appliance in an enclosed shower or bath may cause condensation and rust to develop inside the main body leading to failure.) ►Replacement accessories Replacement accessories are available at your dealer or Service Center. Japanese-style soft brush EH-2S01 Pore-targeting silicone brush EH-2S02 Clean the facial cleanser compartment thoroughly as facial cleanser tends to accumulate in this area. • If you become concerned about dirt accumulating in the brush, apply facial cleanser to the brush and wash it by hand. • Please note that the bristle portion of the silicone brush may come off if pulled strongly. • Please reattach the silicone part if it becomes detached. EH-XC10_AM.indb 15 15 2015/07/21 18:02:25