Panasonic EY4541 EY4541 User Guide - Page 10
Adjusting the base
View all Panasonic EY4541 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
WARNING: If you do not insert the saw blade deep enough, the saw blade may be ejected unexpectedly during operation. This can be extremely dangerous. Removal 1. Lift up the blade Attach/Remove lever. 2. Pull out the blade. Adjusting the base 1. Use the hex wrench to loosen the base fixing screw. Position of base and purpose of use Base adjustment hole position Purpose of use Normal right-angled cutting Cutting at an angle between 0° and 45° 2. Move the base along the base adjustment hole to set its position. (See the diagram at right.) • The base can be adjusted to between 0° and 45° sideways and the forward/back position can also be adjusted. If tilting the base sideways, remove the dust cover first. • Refer to the bevel index to determine the angle. • Rip fence fixing screw should be located on the opposite side tool is beveled. Cutting at an angle of 45° Cutting close to the end of a wall 32 1 0 NOTE: This is only a rough guide. The actual angle of the cut will be affected by factors such as the way the tool is held against the surface. 3. Use the hex wrench to tighten the base fixing screw. - 10 -