Panasonic EY4542 EY4542 User Guide - Page 9

b. extension cord is properly wired and in good electrical condition. c. wire size is large enough for ampere rating of charger as specified below. RECOMMENDED MINIMUM AWG SIZE OF EXTENSION CORDS FOR BATTERY CHARGERS AC Input Rating. Amperes AWG Size of Cord Equal to or greater than But less Length of Cord, than Feet 25 50 100 150 0 2 18 18 18 16 8) Do not operate charger with damaged cord or plug-replace them immediately. 9) Do not operate charger if it has received a sharp blow, been dropped, or other­wise damaged in any way; take it to a qualified service personnel. 10) Do not disassemble charger; take it to a qualified service personnel when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 11) To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. 12) The charger and battery pack are specifically designed to work together. Do not attempt to charge any other cordless tool or battery pack with this charger. 13) Do not attempt to charge the battery pack with any other charger. 14) Do not attempt to disassemble the battery pack housing. 15) Do not store the tool and battery pack in locations where the temperature may reach or exceed 50°C (122°F) (such as a metal tool shed, or a car in the summer), which can lead to deterioration of the storage battery. 16) Do not charge battery pack when the temperature is BELOW 0°C (32°F) or ABOVE 40°C (104°F). This is very important in order to maintain optimal condition of the battery pack. 17) Do not incinerate the battery pack. It can explode in a fire. 18) Avoid dangerous environment. Do not use charger in damp or wet locations. 19) The charger is designed to operate on standard household electrical power only. Do not attempt to use it on any other voltage! 20) Do not abuse cord. Never carry charger by cord or yank it to disconnect from outlet. Keep cord away from heat, oil and sharp edges. 21) Charge the battery pack in a well ventilated place, do not cover the charger and battery pack with a cloth, etc., while charging. 22) Use of an attachment not recommended may result in a risk of fire, electric shock, or personal injury. 23) Do not short the battery pack. A battery short can cause a large current flow, over heating and create the risk of fire or personal injury. 24) NOTE: If the supply cord of this appliance is damaged, it must only be replaced by a repair shop authorized by the manufacturer, because special purpose tools are required. 25) TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. VIII. ASSEMBLY Attaching or Removing Battery Pack CAUTION: Before inserting battery pack, check that the power switch in the tool actuates properly and returns to the "OFF" position when released. 1. To connect the battery pack (See Fig. 2) Line up the alignment marks and attach the battery pack. • Slide the battery pack until it locks into position. Alignment marks Fig. 2 -  -