Panasonic EY7440 EY7440 User Guide - Page 5
For Battery Charger, & Battery Pack - part
View all Panasonic EY7440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
9) Do not touch the rotating parts to avoid injury. 10)Do not use the tool continuously for a long period of time. Stop using the tool from time to time to avoid temperature rise and heat overload of the motor. 11)Do not drop the tool. Symbol V Meaning Volts Direct current n0 .../min Ah No load speed Revolutions or reciprocations per minutes Electrical capacity of battery pack Rotation only WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints • Crystalline silica from bricks and cement and other masonry products • Arsenic and chromium from chemi cally-treated lumber. To reduce your exposure to these chemi cals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles. III. FOR BATTERY CHARGER & BATTERY PACK Important Safety Instructions 1) SAVE THESE INSTRUCTIONS -This manual contains important safety and operating instructions for battery charger EY0L80. 2) Before using battery charger, read all instructions and cautionary markings on battery charger, battery pack, and product using battery pack. 3) CAUTION -To reduce the risk of injury, charge only Panasonic Battery Pack as shown in last page. Other types of batteries may burst causing personal injury and damage. 4) Do not expose charger and battery pack to rain or snow. 5) To reduce risk of damaging the electric plug and cord, pull by plug rather than cord when disconnecting charger. 6) Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 7) An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure that: a. pins on plug of extension cord are the same number, size and shape as those of plug on charger. b. extension cord is properly wired and in good electrical condition. c. wire size is large enough for ampere rating of charger as specified below. RECOMMENDED MINIMUM AWG SIZE OF EXTENSION CORDS FOR BATTERY CHARGERS AC Input Rating. Amperes AWG Size of Cord Equal to or greater than But less Length of Cord, than Feet 25 50 100 150 0 2 18 18 18 16 8) Do not operate charger with damaged cord or plug-replace them immediately. 9) Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified service personnel. 10)Do not disassemble charger; take it to a qualified service personnel when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. 11)To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. 12)The charger and battery pack are specifically designed to work together. Do not attempt to charge any other - -