Panasonic KX-HNC505 Information and Troubleshooting Guide - Page 18

Troubleshooting (Initial setup by selecting "WPS") What is WPS? WPS is a function of wireless routers that is used to easily connect wireless devices to wireless routers. A WPS button on a wireless router indicates that it has the WPS function. (Depending on the type of wireless router, the WPS function may be disabled on the wireless router even if there is a WPS button.) If you have trouble during the initial setup, check the following causes/solutions first. Problem LED color When initial setup The camera's is performed LED indicator is using WPS, the blinking in red. following screen is displayed and the setup cannot be completed. Cause Solution If the LED indicator is blinking in red, unplug the camera and then plug it in again, check the following causes and solutions, and then try again from the beginning. The WPS function on Some Internet Service Provider wireless routers your wireless router may have WPS disabled. may be disabled. • During initial setup select "Bluetooth". The camera and • Move the camera and wireless router closer wireless router are too together. far away. The wireless router is not in WPS mode. • Press the WPS button on the wireless router for long enough until the LED indicator on the router starts blinking. Several cameras are • Only 1 camera can be operated in WPS mode in WPS mode. at a time. The DHCP function of • Confirm that the wireless router's DHCP settings your wireless router are enabled. Refer to your wireless router's may be disabled. manual. The address filter function of your wireless router may be enabled. • Register the MAC address (page 5) of the camera to the address filter setting of the wireless router. Refer to your wireless router's manual. 18