Panasonic MCUG583 MCUG583 User Guide - Page 32
Replacing Belt, Cleaning Agitator, Lift Agitator Up, Felt Packing, Install, New Belt, Motor Shaft
View all Panasonic MCUG583 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Replacing Belt + + Felt Packing Cale en feutre Empaquetadura de fieltro Lift Agitator Up Soulever l'agitateur Unidad del agitador + Motor Shaft Arbre d'entraînement du moteur Eje del motor + + + Install New Belt Poser la nouvelle courroie Instalación de la correa ➢ Replace belt whenever a burning rubber smell caused by excessive slippage occurs. ➢ Remove lower plate. ➢ Lift rear belt cover and remove felt packing. ➢ Remove agitator by carefully lifting out. ➢ Remove worn or broken belt. ➢ Clean agitator. ➢ Loop new belt (Panasonic Type UB8 only) around motor shaft and agitator pulley; see illustration for correct belt routing. ➢ Reinstall agitator back into nozzle housing grooves. ➢ Close rear belt cover and reinstall felt packing. ➢ After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely. Groove Rainure Ranura End Cap Bouchon Tapa del extremo ➢ Reinstall lower plate. Cleaning Agitator ➢ Clean agitator after every five uses and every time the belt is replaced. ➢ Remove lower plate. ➢ Cut off any carpet pile and lint entangled around agitator with a pair of scissors. ➢ Remove agitator. ➢ Remove any string or debris located on the end caps, washers or agitator shaft. ➢ Reinstall agitator and lower plate. - 32 -