Panasonic MCUG583 MCUG583 User Guide - Page 40

BEFORE REQUESTING SERVICE WARNING Electrical Shock or Personal Injury Hazard Disconnect the electrical supply before servicing or cleaning the vacuum cleaner. Failure to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting. Review this chart to find do-it-yourself solutions for minor performance problems. Any service needed, other than those described in these Operating Instructions, should be performed by an authorized service representative. PROBLEM POSSIBLE CAUSE Vacuuum cleaner 1. Unplugged at wall outlet. willnot run. 2. ON-OFF switch not turned on. 3. Tripped circuit breaker/blown fuse at household service panel. POSSIBLE SOLUTION 1. Plug in firmly. Push ON-OFF switch to ON. 2. Push ON-OFF switch to ON. 3. Reset circuit breaker or replace fuse. Poor job of dirt pickup. 1. Full or clogged dust bag. 2. Broken belt. 3. Clogged hose or nozzle. 4. Hose not inserted fully. 5. Worn agitator. 6. Hole in hose. 7. Dust cover improperly installed. 8. Belt not installed on motor shaft. 1. Change dust bag. 2. Replace belt. 3. Clean hose or nozzle area. 4. Insert hose. 5. Replace agitator. 6. Replace hose. 7. Properly install dust cover. 8. Install belt on motor shaft. Dust escapes the paper bag. 1. Bag improperly installed. 2. Bag torn. 1. Properly install bag. 2. Replace bag. Light will not work. 1. Burned out light bulb. 1. Replace light bulb. - 40 -