Panasonic MCV5744 MCV5744 User Guide - Page 28

Removing And Installing Lower Plate - nozzle housing

Get Panasonic MCV5744 - UPRIGHT VACUUM PDF manuals and user guides View all Panasonic MCV5744 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

WARNING Electrical Shock or Personal Injury Hazard Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Removing and Installing Lower Plate Two Latches Dos pestillos Deux taquets Two Locking Tabs Dos lengüetas de cierre Deux loquets de sûreté Lower Plate Base inferior Plaque inférieure ➢ Before servicing any parts, disconnect vacuum from electrical outlet. ➢ Always place paper under nozzle whenever lower plate is removed to protect floor. ➢ Place handle in upright position and turn vacuum over to expose lower plate. ➢ Release lower plate by pressing two (2) latches and two (2) locking tabs inward as shown. ➢ Remove lower plate and remove any residue that may exist in belt area. ➢ Reinstall lower plate by hooking front end of lower plate into slots on front of nozzle housing. ➢ Make sure all wires are routed properly and not pinched. ➢ Press lower plate until locking tabs snap into place then push the two (2) latches outward. - 28 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
- 28 -
WARNING
Electrical Shock or Personal Injury Hazard
Disconnect the electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury from
cleaner suddenly starting.
Two Latches
Dos pestillos
Deux taquets
Two Locking Tabs
Dos lengüetas de cierre
Deux loquets de sûreté
Lower Plate
Base inferior
Plaque inférieure
Removing and Installing Lower Plate
Before servicing any p
art
s,
disconnect vacuum from electrical
outlet.
Always place paper under nozzle
whenever lower plate is removed to
protect floor.
Place handle in upright position and
turn vacuum over to expose lower
plate.
Release lower plate by pressing two
(2) latches and two (2) locking tabs
inward as shown.
Remove lower plate and remove any
residue that may exist in belt area.
Reinstall lower plate by hooking front
end of lower plate into slots on front
of nozzle housing.
Make sure all wires are routed
properly and not pinched.
Press lower plate until locking tabs
snap into place then push the two (2)
latches outward.